Part Number: LMP90097 Hi,
I'm planning to use the LMP90097 to measure two sensors: a thermistor and a photoionization detector (PID).
The output of the PID goes to its own amplifier and the output range of that amplifier is -12V to +12V, which I will…
Part Number: LMP90100 Other Parts Discussed in Thread: LMP90099 , LMP90098 , LMP90097 , LMP90080 , LMP90079 , LMP90078 , LMP90077 , LMP90080-Q1 Tool/software: Hi,
What is the protocol to read register data on my LMP90100?
Part Number: LMP90100 Other Parts Discussed in Thread: LMP90099 , LMP90098 , LMP90097 , LMP90080 , LMP90079 , LMP90078 , LMP90077 , LMP90080-Q1 Tool/software: Hi,
I'm enabling the CRC function in my LMP90100, but I'm only reading zeroes when I read…
Part Number: LMP90080 Other Parts Discussed in Thread: LMP90100 , LMP90099 , LMP90098 , LMP90097 , LMP90079 , LMP90078 , LMP90077 , Tool/software: Hi,
I’m trying to use CRC to ensure integrity of data on my LMP90080, but my externally calculated value…
Hi Juliana,
For the LMP90100, its own errors are corrected in the background using the continuous background calibration.
If you want to do system (sensors + LMP90100) correction, then yes, this will be done using the microcontroller system. Feel…
Other Parts Discussed in Thread: LMP90099 , LMP90097 , LMP90100 An application note is badly needed for the AFE Sensor Diagnostic Flags, because vital information is missing from the datasheet.
Specifically, Figure 18 shows that sensor diagnostic…
Not having any information about your setup, I suggest that you please make sure that the correct configuration sequence is stored in the proper registers. For sample C codes, please refer to the attached apps note
snaa075a.pdf
