Hello,
This is a mistake in both the TCI6630K2L and 66AK2L06 datasheets. The VDDCMON K10 should either be the CVVD Feedback source, or unconnected.
This signal is an internal Power Distribution monitor for CVVD. You need to isolate this from CVDDS…
Other Parts Discussed in Thread: DRV8312 , INSTASPIN-BLDC Hi all,
I am studying about methods of controlling BLDC motor (type of trapezoidal back-EMF synchronous motor). I also tried to control a BLDC motor with a TI's evaluation kit named DRV8312 C2…
Hi Alyssa,
Here is the data sheet that was revised in 2001. It doesn't have any lot marking information, and unfortunately I don't know if we have a way to get that information. Are you just trying to verify it is not counterfeit?
Regards, Mike
…
Hi Soumya,
TPS54116 is peak current mode controller. Attached is the spreadsheet to calculate gain and phase margin.
BUCK_CALC_TOOL_180309_TPS54116Q1.xlsx
Spreadsheet calculates the power stage gain, compensation gain and total gain. That should…
Hi Ulrich,
Thank you for your elaborate reply!
Here are the schematic and calculation xls:
UCC28600 huplvoeding 320-760VDC 40W.xls
I tried a 30V schottky (bat54s) across the CS pin, this did nothing whatsoever. I will order a lower voltage schottky…
I have attached document that describes the correct installation procedure and process for connecting to the gauge to communicate. See if you can get the EVSW to work with this guide. If not, there may be an issue with the chip, the EV2300, or any of…
Part Number: TPS536C7 Other Parts Discussed in Thread: TPS53676 , Hi, TI expert
A customer has an inquiry about Multiphase PWM Controller.
- Customer: FURIOSA AI ( https://www.furiosa.ai/)
- Application: AI (GPU card), refer to the link below
…
Thanks reply!
The hardware is modified from the EVM，m ost important parts have not been modified，the bootmode we just use a 5bit switch, but I used the resistances to follow the EVM mode. The attachment is our schematic diagram. And use this hardware…
