Search tips
Showing 20 results View by: Thread Post Sort by

  • LP38513-ADJ

    Other Parts Discussed in Thread: LP38513-ADJ Hi, We are after the coefficient of thermal expansion figure for the LP38513-ADJ. Thanks, Jani

  • WEBENCH® Tools/LP38513-ADJ: TI Model Issue

    TI Thinks Resolved
    Part Number: LP38513-ADJ Tool/software: WEBENCH® Design Tools A few weeks ago I modeled a circuit using the TI Webench tools. The model included the LP38513-ADJ 3A voltage regulator with the following parameters: Vin = 4.5-5.5VDC Vout = 1.1VDC …
    • Answered

  • LP38513-ADJ: feed forward capacitor to slow inrush

    Resolved
    Part Number: LP38513-ADJ Other Parts Discussed in Thread: LP38502-ADJ , TPS7A85A , TPS7A83A I am looking at using a LP38513-ADJ or a LP38502-ADJ to provide a 4V supply from a 5V source, and I would like to try to use a feed forward capacitor to slow the…
    • Resolved
    • Answered

  • Maximum current output of LP38513-ADJ

    Resolved
    Other Parts Discussed in Thread: LP38513-ADJ Hi,all I am planning to use LP38513-ADJ for conversions from 2.5V rail to 1.9V.The current needed is 2A. In the datasheet the maximum output current is 3A,but when i evaluate this LDO by WEBENCH,the maximum…
    • Resolved
    • Answered

  • LP38513-ADJ and LP38503-ADJ Thermal Pad connection

    Resolved
    Other Parts Discussed in Thread: LP38513-ADJ , LP38503-ADJ Is it possible not to connect the thermal pad of LP38513-ADJ and LP38503-ADJ (D2PAK-5 package) to Ground. This way only pin 3 will be used for electrical connection. Theramal performance will…
    • Resolved
    • Answered

  • Regarding LP38513-adj regulator Heat sink recommendation

    Resolved
    Other Parts Discussed in Thread: LP38513-ADJ Dear Sir, I am planning to use LP38513-adj regulator for 3.3V and 1.2V. Please recommend the appropriate heat sink model for this regulator to place in the PCB. Thanks, V. Prakash
    • Resolved

  • LP38513 for constant current source

    Other Parts Discussed in Thread: LP38513-ADJ , LP38513 Dear Sir, My customer develope a contact resistance measurement instrument with 4wires configuration. that is to say exicate currrent source and output signal is seperated. LP38513-ADJ is recommended…

  • RE: ADC08D1520RB ADC Chip cannot be powered up

    Hello Bridget, The 6th pin of LP38513-ADJ is the ground pad located on the bottom side of the device. The voltages you are seeing on those pins are not correct however and imply that the input voltage to the device (Pin2) is too low. Here are what…
    • Answered

  • Re: TPS62290 3.3V output ripple 500mV for 1A max load

    Resolved
    Hi Sir, Can i use LP38513-adj to generate 3.3V and 1.2V? Can i add the 8 x 10 uf capacitor in the output bus (decoupling) using this regulator. please let me know. Thanks, V. Prakash
    • Answered

  • RE: ADC12D1600RB: Where to download the reference design/layout of the board?

    Resolved
    Hi Alex, I think I have found what the issue may be - I believe the files are outdated. Please try with the below file. 3771.ADC12D1X00RF_RB-SCH_B.pdf Thanks, Chase

Didn't find what you are looking for? Post a new question.