Hi Shlomi,
What you can do is:
1. Connect the analog hall outputs to HPx
2. Bias the HNx to a constant voltage equal to (hall output peak to peak voltage)/2. This should work for a single ended hall output.
3. Please do consider the following bounds while…
Part Number: MCT8316ZTEVM
Tool/software:
My team is using MCT8316ZTEVM for stall torque measurements with duty cycle from 10% to 100%.
Q2 FET that got punctured is part of the Reverse Battery Protection Circuit. My understanding is that Q2 FET gets turned…
Part Number: MCT8316ZTEVM Other Parts Discussed in Thread: MCT8316Z , Tool/software: Hi..
One of my cusotmer is working on one of the project for which they are considering MCT8316Z.
We have share MSP430ZTEVM with their team & they want to have source…
Hi Linus,
We do test our EVMs for functionality and all devices are tested to meet datasheet specifications before delivery. I will need to reach out to our team about this issue. I will aim to get back with you by 4/19.
Regards,
Joshua
Part Number: MCT8316ZTEVM Other Parts Discussed in Thread: MCT8316Z Hello I am testing MCT8316ZTEVM, and I have some questions;
(1) RED LED (set for nFAULT) keep flasing, what status does it stand for?
(2) When the alarm generated, is the nFAULT always…
Part Number: MCT8316ZTEVM Hello everyone,
in the following thread
MCT8316ZTEVM: SPI Firmware support for the on board MSP430 - Motor drivers forum - Motor drivers - TI E2E support forums
is a link to an unfinished Demo GUI for SPI communication with the…
Part Number: MCT8316ZTEVM Hi
I'm using MCT8316ZT EVM and to drive BLDC motor.
I have checked the coil current by probing using oscilloscope current probe.
For constant duty cycle 50% (Open loop) coil current waveform:
For PID close loop coil current…
Part Number: MCT8316ZTEVM Hi team,
The device is severely hot in the circuit(designed by customer).
They use hardware to set driver chip parameters. The parameters are as follows:
Slew rate is 200V/us, lead angle increment of 0, PWM mode is digital hall…
Part Number: MCT8316ZTEVM After connecting all the hall wires (digital), Power and USB I turned the potentiometer anti-clockwise but the motor did not spin. Instead it would 'vibrate' in place. I tried various combinations of motor phase and hall wire…
Part Number: MCT8316ZTEVM We have purchased MCT8316ZTEVM evaluation module vide our Order No. T03830710 to run a motor.
Whenever we set low duty cycles on eval kit using provided potentiometer, nFAULT LED starts glowing, and motor stops running. It takes…
