Part Number: MPC506 Other Parts Discussed in Thread: SN74LXCH8T245 Tool/software: Hi, I've got 2 MPC506 devices in parallel and I control the address bits together and the enables opposite using 5V logic levels to sequence through 32 analog input channels…
Part Number: MPC506 Other Parts Discussed in Thread: CD74HC4067 Hi TI
I am going to use MPC506 to select up to 15 channels, analog, and digital signals will be passing to the output pin.
Is it possible to power it with a single power supply +5V and…
Part Number: MPC506 Hello,
My customer has a question for MPC506.
MPC506 has overvoltage protection.
But there is no information about the leakage current at the overvoltage condition.
When the supply voltage = 0, how much leakage current…
Part Number: MPC506 Hi Team, I would like to get your input with the customer design using MPC506 to read a number of 15 signals (analog and digital).
The customer would like to confirm if he can supply it with +5 volts and leaving the negative voltage…
Other Parts Discussed in Thread: MUX509 , MUX508 Hi everyone,
I have problem with MUX MPC 506. I need to process analog signals coming from 9 sensor. How should I desgn a circuit for obtaining 9 data one by one at output of MUX?
Regards
This thread is closed due to inactivity. If you have a question or comment on this topic, please feel free to continue the conversation here -- just don't expect the OP to respond!
Other Parts Discussed in Thread: MPC508 Hello,
MPC508 datasheet has “CROSSTALK vs SIGNAL FREQUENCY” characteristics on page4, but does not have test circuit information.
Please let me known test circuit information and what is “Rs” in the Figure.…
Other Parts Discussed in Thread: OPA2170 , ADS1018 , MPC506 Hi,
I'm developing a 32 channel PLC analog interface with signal ranges from 0-10V or 4-20mA that will be converted to 0-5V trough a 250ohms sense resistor.
I'm planning to use a resistor…
I'm performing an accuracy analysis, and I would like to know the delta leakage current between channels. The specific parameter is Id(ON). Should I assume that all mux channels have the same Id(ON) of 10 nA or is one channel 0 nA while another is 10…
