Part Number: ONET1151P Tool/software: Hi,
can I connect these two drivers with 2 wires of I2C (SCK and SDA) in cascade connection? each driver gets different address
do you have any layout recommendation for this connection?
Part Number: ONET1151P
Tool/software:
Hi,
I have few questions regarding ONET1151P wiring.
1. I've got LVDS signal as an input with Vcm = 1.2v and Vd = 350mV. The signal doesn't get detected by the amplifier, probably due to common mode. I played…
Part Number: ONET1151P Hi,
TIDR437 is the TI ref design for the 10G Optical module, which is for the fixed wavelength laser technology. We need the reference design for the 10G Optical module for DWDM application, whose laser can be tuned to C-BAND…
Part Number: ONET1151P Hi there!
The ONET1151P has only one I2C address available.
Is there a way to get off the shelf ONET1151P with different I2C addresses?
Are there any alternative ICs from TI with different I2C addresses available?
Thanks…
Part Number: ONET1151P Hello everyone,
I am looking at the reference design for building a SFP+ model and I noticed something weird.
The design expects a 3.3V source coming into the device via VCCR and VCCT.
This voltage is then fed into a Step…
Part Number: ONET1151P Other Parts Discussed in Thread: ONET1191P dear:
Customer is looking for a LA chip that can be applied to 10G APD ROSA, is ONET1151P can be match, Thanks
Hi Revanth,
As long as pcb layout allows you can require your pcb fab house to fab 100-ohm differential impedance. When it is not possible - since PD pins are far apart - then you can use single ended 50-ohm trace impedance.
Regards,, nasser
