Part Number: OPA2171-Q1 Other Parts Discussed in Thread: OPA171
Tool/software:
Hi Team,
Please help to review OPA2171-Q1 schematic, thanks.
The differential input full-scale voltage will be approximately ±1.25 V, output range would be 0~5V
Part Number: OPA2171-Q1 Other Parts Discussed in Thread: LM2904-Q1 , Hi team,
Do we have any guidelines on how to design RC filter when using OPA2171-Q1 or LM2904-Q1 as differential amplifier? Customer found that too small R value influence response…
Part Number: OPA2171-Q1 Hi,
My customer is using OPA2171-Q1 for sensing application on OBC but there is some unexpected power-up sequence. so, they want to know wether it will be damaged the component or not.
the V+(12V) late after (about max few…
Part Number: OPA2171-Q1 Other Parts Discussed in Thread: OPA2171 Hi Experts,
For below output voltage swing range of OPA2171-Q1, is it guaranteed in whole life time under -40-125C temperature range? Due to the aging of the components, will it cause…
Part Number: OPA2171-Q1 Hello Team,
I have a question about slew rate value of OPA2171AQDGKRQ1.
Our customer requested us that the slew rate is higher than 0.47V/us. So I want to make sure the OPA2171-Q1 can meet the customer request.
Q. How much…
Part Number: OPA2171-Q1 Hi, Could you provide the OPA2171-Q1 Pin FMEA like follows? http://www.ti.com/lit/an/slva627/slva627.pdf
Best Regards, Yusuke/Japan Disty
Part Number: TLV9154-Q1 Other Parts Discussed in Thread: OPA2171-Q1 Hi team,
Is it MUX friendly device? Could we use it as comparator on open-loop?
https://www.ti.com/product/TLV9154-Q1 "Product details"says "MUX friendly" but its datasheet does not…
Hello Shaq,
The TL082-Q1 was automotive qualified to the standard active in 2007. The qualification likely does not meet AEC-Q100 Rev H.
We have a similar device, OPA2171-Q1 that is AEC-Q100
Part Number: TLV2374-Q1 Other Parts Discussed in Thread: OPA2171-Q1 , LT1014 , LT1013 Hi
I found this post. I understand the some method is allowable to prevent the negative input for this device.(input resistance and clamping diode)
On the other…
Part Number: OPA4171-Q1 Other Parts Discussed in Thread: OPA2171 , LM2902 , LM2903 , LM2901 Tool/software: Hi team,
I want to check with you if OPA2171/4171-Q1 can be used as comparator input? I saw some amplifiers without bi-directional diode at input…
