Part Number: OPT3001-Q1 Tool/software: Dear TI Engineer,
Our FPCA product uses OPT3001DNPRQ1 as the light sensor for vehicle, but the device ID read by different end customers on the same device is different. The Tier1 manufacturer read the device ID…
Part Number: OPT3001-Q1 Tool/software: Please confirm the detail of below text.
What is the surface resistance of the ESD material required for adequate protection?
Please check whether you need a material with a conductive area of 10^5 or less, or…
Part Number: OPT3001-Q1 Please give me the shipping inspection standard of OPT3001-Q1.
The data sheet of this component indicates potential risk of the discoloration, scratches, fingerprint and dust.
I want to understand what kind of shipping inspection…
Part Number: OPT3001-Q1 Dear team,
My customer GWM-NOBO is using OPT3001-Q1 as light sensing. They need the sensing area's position in the IC to decide the mechanical parameter of opening.
Could you please share it?
Part Number: OPT3001-Q1 Hi team,
My customer have questions about OPT3001-Q1 output variation.
・ The following variation in measurement output is approximately +/- 10%. Is the variation from the initial tolerance?
・ In addition, what is the measurement…
Part Number: OPT3001-Q1 Other Parts Discussed in Thread: OPT3006 , OPT3001 Hi team,
As shown in the picture, because it is relatively close to the edge of the revision, I would like to know how small the diameter of the ALS hole on the cover plate should…
Part Number: OPT3001-Q1 Other Parts Discussed in Thread: OPT4001-Q1 Hi Team,
I would like to check if our OPT3001-Q1 and OPT4001-Q1 can meet the spec or not. smoke print spec 14%+-4% in 550nm
Regards,
Roy
Part Number: OPT4001 Other Parts Discussed in Thread: OPT3001-Q1 , , OPT3001
Hello Team, Our customer want to know about following points between OPT4001-Q1 and OPT3001-Q1.
Package and pin assignment compatibility
Operating temp and voltage condition…
Part Number: OPT3001-Q1 We are using custom board with jetson nano, we need to configure interrupt functionality in opt3301 in latched window style comparison mode, as per data sheet we need to clear a bit every time when interrupt occurs. Can you specify…
Part Number: OPT3001-Q1 Hi team,
Is there any risk to block the I2C if reading the result before a conversion is complete?
Customer set the conversion time to 100ms, and the system will poll the result register(0x0) every 100ms. Any risk?
B&R
Liji…