Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: PCM1681 Tool/software: Hello Ti Teams,
I am Chauhan Mihir and i am working in Aimtron Technologies Pvt.Ltd as Hardware Design Engineer. Currently i am working on New project. The project is in design phase and i am looking for use "PCM1681PWPR…
Part Number: PCM1681 Tool/software: Hi
I am using PCM1681. So when I am generating a sine wave from DAC, I am observing lot of noise. Datasheet mentions that there will be out of band noise at the output, which we need to remove using an external active…
Part Number: PCM1681-Q1 Tool/software: Hi,
I have a customer using the following device, and they had a question about the types of capacitors spec'd in the datasheet. The data sheet calls for two 10uF capacitor caps which should be tantalum or aluminum…
Part Number: PCM1681
Tool/software:
Hello,
I am using the PCM1681 in my design with an SCK of 12.28MHz, a BCK of 3.072MHz and a LRCK of 48kHz. I have the 24-bit audio data connected to the DATA1 pin and is provided in Left-Justified format. The DAC is…
Part Number: PCM1681
Tool/software:
Hello, experts.
Please tell me about the output of the clipped SINE waveform of the PCM1681 as soon as possible.
The figure below shows the circuit configuration and the observation waveform when the clipped SINE…
Part Number:
Tool/software:
Hello, experts.
Please tell me about the output of the clipped SINE waveform of the PCM1681 as soon as possible.
The figure below shows the circuit configuration and the observation waveform when the clipped SINE waveform…
Part Number: PCM1681-Q1 Tool/software: Hi team,
I would like to check with you if PCM1681-Q1 support TDM8 input? I don't find it in datasheet.
If no, please help recommend the device which have 8ch TDM8 input DAC device.
Thanks!
Ethan Wen
Part Number: PCM1681 My customer is looking at PCM1681 for a non-audio application. The data output rate to the DAC channels would be <= 20kHz. Could you please help with the following:
Would it be possible to disable any intermediate processing blocks…