Part Number: PCM6020-Q1 Hi team,
For input protection purpose, I plan to insert resistor in series to the ADC input to protect it from negative voltage input condition.
Could you advise the maximum current that PCM6020 can tolerate, so that I can select…
Part Number: PCM6020-Q1 Hi team,
Could you give me slave version of the I2S timing diagram as in datasheet Figure 8-5. and Figure 8-8.
I would like to know the timing between FSYNC/BCLK/SDOUT depends on BCLK_POL difference.
I set BCLK_POL to High and…
Part Number: PCM6020-Q1 Hi team,
How much should I wait after releasing SHDNZ of PCM6020-Q1?
There are 2 description in the datasheet which mention slightly different number. 1ms vs 2ms.
In the datasheet Page 119
"2. Transition from hardware shutdown…
Part Number: PCM6020-Q1 Hi team,
Could you confirm if my understanding below correct?
What is the BSTOUT voltage? --> 1V above set MICBIAS voltage.
How much is the BSTOUOT switching frequency --> 6.144MHz (at fs=48kHz) or 5.6MHz(at fs=44.1kHz) …
Part Number: PCM6020-Q1 Hi team,
I found the default value of following resistor is different from the default datasheet value.
Could you check if my reading value is correct or not?
P4_R72-R75 = 0x7FE648C6 (default : 0x7FFFFFFF) P4_R76-R79 = 0x8019B73A…
Part Number: PCM6020-Q1 Hi team,
Is there a risk under the normal operating condition to put the device into its test / diagnostic mode which should be used only for your(TI) debug or manufacturing purpose?
regards,
Part Number: PCM6020-Q1 Hi team,
Could you advise the typical and maximum supply current for Iavdd/Ibstvdd/Iiovdd under the condition below?
Mode : slave mode
fs = 384kHz
BCLK = 64 x fs
MICBIAS = 9V (AC-coupling) @Rext=4.7kohm
I2C bus
regards,
Part Number: PCM6020-Q1 Other Parts Discussed in Thread: PCM6240Q1EVM-PDK Hi Team,
Would you advise can TI provide EVM of PCM6020-Q1?
What's the EVM name for order?
Thanks
Best regards,
Shidara
Part Number: PCM6020-Q1 Hi team,
Regarding to PCM6020-Q1 power up/down sequence.
1. tf
Is there tf requirement?
2. What is the concern if tr is higher than 1 V/μs?
regards,