Gijs,
Yes, you can communicate with up to 8 PGA460's on the same bus. Note that each device will need to have an address programmed to it before all devices are on the bus. See the thread below which has some good detail of how to set the address. …
Part Number: PGA460-Q1 Other Parts Discussed in Thread: PGA460 Tool/software: Hello,
I'm searching for an integrated solution for ultrasonic car alarm.
The PGA460-Q1 can be used as motion detector (doppler effect detecion) with a pair of transducers…
Part Number: PGA460-Q1 Other Parts Discussed in Thread: PGA460 , BOOSTXL-PGA460 , UNIFLASH ,
Cannot seem to install drivers to run the PGA460 EVM with MSP430. Using the GUI I get the following message:
I'm running windows 10 and my computer is…
Part Number: PGA460-Q1 Other Parts Discussed in Thread: PGA460
Hi TI:
Does USS solution support kick tailgate function?if no,what solution can support this function for TI?
Part Number: PGA460-Q1 Other Parts Discussed in Thread: PGA460 Tool/software: Hi
in my cusotmer's applicatio the PGA460 need to connect to 3.3V MCU. so we need to pull low the test pin (Pin 9)
Can we use 0 ohm to connect this pin to ground directly…
Part Number: PGA460-Q1 Tool/software: Dear Texas Instruments,
I am currently using the PGA460-Q1 ultrasonic driver with a 40 kHz transducer. The system works well in detecting objects within the range of 30 to 300 cm, returning accurate distance measurements…
Part Number: PGA460-Q1 Tool/software: Hi
In datasheet schematics we saw a 100uF capacitor. (as below picture shows)
in our applicationn OUTA and OUTB will below 7V and TX frequency is ~ 200KHz.
how do we select this capacitor value ?
due to space…
Part Number: PGA460-Q1 Tool/software: Hi Team,
Regarding SLAA733 Frequently Asked Questions...
Section 5.11 provides an equation for the distance vs ultrasonic time which takes account of the time spent bursting however I have discovered that the…
Hi Keith,
In regards to the false triggering, it sounds like you may be having a similar issue to what is described in section 5.6 of the FAQ below. The data comparator ramps during the burst and listen period and if that signal is not saturated, this…
Hello Issa,
The register (REC_LENGTH) data from address 0x22 has been been verified to be 0x19 (as above). P1_REC is 8.192 ms , while P2_REC is 40.96ms. The unwanted data occurred at 6.4ms ~8.192ms.
Beforehand, I had checked the following:
1a…
