Part Number: PLL1705 Other Parts Discussed in Thread: PLL1706 Hello,
I am using the PLL1705 for a system clock of 24.576 MHz at SCKO2. Moreover I am using the Hardware mode.
What should I do with the three-wire interface ML(PIN 7), MC (PIN 6) and…
Part Number: PLL1705 Other Parts Discussed in Thread: TAS5753MD , CDCE913 If I have two I2S audio sources configured as slaves driving a TAS5753MD speaker amplifier, is there a simple I2S "controller" IC that can generate the SCLK and LRCLK to all three…
Other Parts Discussed in Thread: PLL1705 Hello! I solded my PLL1705 on a adaptor board and connected it to the breadboard, connections had already been checked and there is no fault, the circuit is properly connected with a 27MHz crystal.
however,…
Other Parts Discussed in Thread: PCM1792A , PLL1705 , TMS320F28335 Hi,
my
design is based on F28335 microcontroller, which provides PCM1792A DAC
through McBSP serial port with serial PCM data. I wanted to use PLL1705
to clock both of those devices.…
Hi Eric,
Do you have requirements on the clock jitter? Do you need all thee frequencies simultaneously? Or any other requirements?
You may be interested in an audio clock such as PLL1705. PLL1705 can generate one of these frequencies at a time on…
Part Number: PCM1808 Other Parts Discussed in Thread: PLL1705 Hi all,
I'm trying to get audio data from line in (phone, pc,..) and stream via UDP protocol.
I use a ESP32 to communicate with a PCM1808 breakboard, below figure is my hardware connection…
Part Number: TMS320DM6437 Other Parts Discussed in Thread: PLL1705 I can't understand the concept of Audio PLL/VCXO Circuit/PLL1705 Clock Generator while reading the tech reference manual of DM6437.Please explain the concept clearly
xixi,
From what I understand, you need to generate output clock signal on the AM5708 mcasp2_ahclkx pin. But why you are doing this? From what I understand, you supply PCM1681 SCK clock input from pll1705 clock generator. What is your purpose with AM5708…
Other Parts Discussed in Thread: OMAP-L137 , PLL1705 , TLV320AIC3106 Hello, I have got a problem when I implement a FIR with coefficients greater than 25. It's OK for a FIR with 24 coefficients but when I put 25 coefficients or more, the filter doesn…
Other Parts Discussed in Thread: SRC4192 , PLL1705 Dear Sir
i have tested SRC4192 evaluation board and get below observation
Setting
1. 16bit 44.1K signal input from SPDIF to CS8414 BCLK, data, LRCLK to SRC4192
2.SRC4192 clock source by PLL1705…
