Part Number: PMP10110 Other Parts Discussed in Thread: PMP10100 Tool/software: Hello
In the PMP10100 reference circuit, is it possible to change the output voltage to 30V and the output current to 24A?
Can I change the time constant of the…
Part Number: PMP10110 Tool/software: Looking at the PDF documents of the PMP10110 Universal AC Input to 30Vmax@6A Lead-acid Battery Charger Reference Design with PFC, it seems that the design has been made using Altium.
Are these design files (SchDoc…
Part Number: PMP10110 Other Parts Discussed in Thread: LM5039 , UCC27714 , Hi team,
PMP10110 reference design | TI.com
Application Note 2025 LM5039 Evaluation Board (Rev. C)
Compare both board. Why the PMP10110 reference design need to add extra…
Part Number: PMP10110 Hi Team,
I want to use this design for Battery charger,48V,5A ,250W and i need to change V and I set point over time(cc,cv),i am planning to use low cost ST controller for Monitoring Purpose and LED indications.
Kindly suggest…
I agree with you Arpan, But in the unencrypted list of Spice models, there is no half bridge driver of 500V and above . Could you please provide with a half bridge driver's ( 500V and above) unencrypted model
Hi Venkatesh,
You can use the feedback section from PMP8740 and add the optocoupler, similarly to the design PMP10110 ( https://www.ti.com/tool/PMP10110) .
In PMP8740, D1 and D3 are pulling down pin 2 of U2, while R2 is the pull-up resistor.
It…
Part Number: LM5039 Other Parts Discussed in Thread: PMP10110 Hi Team,
There is a good new that we could DIN LM5039
And two questions need you confirm , thanks
<1> Will the following two groups of practices make any significant difference to the…
Part Number: LM5039 Other Parts Discussed in Thread: LM5022 , , PMP10110 , UCC27524 Hi Team,
We find a new project : Spec is 14-160Vin , Vo:24V(150W)
Customer would like to use boost(LM5022) + half bridge(LM5039)
Is it feasible? Is there anything…
Other Parts Discussed in Thread: TIDA-010216 , UCC27524 , BQ76952 , UCC27517 , UCC27624 , PMP10110 , UCC27714 , PMP21529 , UCC27211A Non-isolated gate drivers are used in battery applications. This will go over multiple different applications, the benefits…
Hi Bernadine,
We don't have dedicated chargers to handle the required voltage. There is a reference design on ti.com that might help. www.ti.com/.../PMP10110
It is PFC boost Front-end + half bridge DC-DC. The DC-DC has to be redesigned for your application…
