Other Parts Discussed in Thread: PTH08T240W , PTH08T210W , PTH08T230W Hi,
We would like to find the correct Rtt for C0 values in our PTH08T210W, PTH08T240W and PTH08T230W design.
In the datasheet, the Co is the total output capacitance. Is that means, Co…
Other Parts Discussed in Thread: PTH08T210W
We need the thermal characteristics of this device. Are there two seperate IC's on the board? The board this device mounts to will not be air cooled. It will only be conduction cooled. Will conduction through…
The datasheet for the PTH08T210 module has a section on page 21 about the remote sense inputs.
It says that the sense pins have internal low-value resistor connections to the respective output nodes.
Whilst this gives a number of 15ohm or less, I…
Sir thanks for clarifying my previous questions, the Technical support from India by e-mail is not responding me quickly!!
Can i input 12V , 1A to PTH08T210W to get 1V , 30A output. i.e.
Can I input 12V, 1A from simple LM317 and give it to PTH08T210W to…
Hi Steve,
Yes, the device can operate at 85°C ambient natural convection depending on your operating conditions . For a Vout = 5V, no. We would recommend implementing a forced cooling. For a Vout less than or equal to 3.3V, yes. It should operate just…
Other Parts Discussed in Thread: PTH08T210W I didn't find thermal specification of PTH08xxx modules in the datasheets. The only information I found is about the Overtemperature Protection, in which it says "Always operate the regulator within the specified…
Other Parts Discussed in Thread: PTH08T210W , PTH08T220W Hi,
I'm using the auto-track inputs on PTH08T220W and PTH08T210W in a design for a client.
The datasheets for those parts specify a maximum slew rate "capability" on the auto-track inputs of…
TI has two modules which will meet your requirements. You did not mention the ambient temperatures or air flow in this application.
A. 12V in and 5V out at 4-6A
1.PTH08T230WAx up to 6 amp module for 5Vout with 100LFM air flow and 85°C at 6amp. If the output…
I'm using several PTH08T2xx modules in my design, which include one PTH08T210 that doesn't have SmartSync. Does it still benefit if I enable SmartSync on other modules (PTH08T220/PTH08T230)? In the datasheet of PTH08T210, I see such a mixed design (Fig…
