Part Number: REF35 Hi. REF35300YBHR - This is the part that I have previously used in my project which has output voltage and output current as 3V and 10mA. Now, I need a new part with output voltage as 3.3V and Output current which can have a range of…
Part Number: REF35 Hi,
Can you please provide the feature size for REF35125QDBVRQ1?
The feature size, also referred as "technology node" or "process node", it's the length of the silicon channel between the source and drain. It's typically measured…
Part Number: REF35 Hi Team,
We are currently using your product REF35300YBHR in our design.
Now we have a new requirement looking for an LDO that matches with below specs,
Output volatge/Current - 3.3V/ 100-150mA.
No thermal shutdown or over…
Part Number: REF35 Tool/software: I need to get a copy of the C of C for this part.
Mouser purchased the part number REF35120QDBVR on our PO 029-CA238. we received parts around 4/24/2025.
date code 2426
lot code 4605156HNA
I am not able…
Part Number: REF35 Tool/software: Hi, Please suggest a Vref Generator part number and it should have variable output using margining DAC. Like, if we have ADJ pin in the Vref Generator, we can connect resistors with output and ADJ pin and that node can…
Part Number: REF35 Tool/software: Dear to whom it may concern
I am using the followin logic ICs. I would like you to tell me the country of origin for each device.
REF35300QDBVR
Best Regards,
Part Number: REF35 Tool/software: Hello TI team,
We are using some TI ICs in power section of our design. The Designator and its part numbers are as below,
1. U24: REF35300QDBVR
As we have completed the layout we would like to review it from TI…
Part Number: REF35 Other Parts Discussed in Thread: LM4121 , , REF30E Hello guys,
One of my customers uses LM4121AIM5-1.2/NOPB(Vo=1.250V) for thier mass-production.
They are looking for a alternative device for LM4121AIM5-1.2/NOPB because LM4121 is…
Part Number: REF35 Hello,
We are using a REF3525 (2.5V) voltage reference in a design, with an inverting opamp, to generate a -2.5V reference.
Is it possible to wire the device between GND and -5V rails, to generate -2.5V without using an opamp? …
Part Number: REF35 Tool/software: hi sir
We would like to design a meter, need a current source to driver the sensor as below
REF35 is a good solution for this application?
thanks
