Other Parts Discussed in Thread: Z-STACK , SYSCONFIG These guidelines are intended to provide a reference for all stages of development using TI Zigbee® connectivity products.
Step 0: Learn the technology
Step 1: Pick your device
Step 2: Download…
Dear Michael,
Thank you for your support, also sorry for my misunderstanding.
1. So TI do not have detailed internal diagram of WAKE pin. Right?
2. TI also do not nave ranged values of resistors inside so we should estimate it based on the other…
Part Number: ADS1675 Other Parts Discussed in Thread: OPA211 Hi team,
In the ADS1675REF board reference Riso + DFB buffer circuit, the Riso(R25) is 100ohm, Rf(R22) is 49.9ohm, Cf(C22) is 0.15uF, this is very different from the design method of the…
Hi Arie,
Both antenna and factory calibration are required.
In terms of antenna calibration, it's best to be performed by customers on their own devices. The stored values for antenna calibration are mostly coded in customer SW not the radar.
Please…
hi Mallika,
Could you let us know which register we provided is correct?
The measured Rsense between DAQ and INA4230 is the same one.
Some condition:
It is common GND already. Estimated max current is 10A. Rsense is 3mOhm. The estimated max is…
Other Parts Discussed in Thread: CC1350 , CC1310 , SYSCONFIG These guidelines are intended to provide a reference for all stages of development using TI Sub-1 GHz Wireless MCUs. This guide doesn't cover the development using TI's range of transceivers…
I am considering implementing a precision current source using LM4051-N as the voltage reference, precision resistors (R1 and Rs), and a BC857 transistor.
I would appreciate help in estimating the achievable current stability over the automotive temperature…
Hi,
Sorry for the delay,
I think you should perform some testing with the current EVMs we have available. Even if the antennae characteristics fully match your requirements you will have an idea if the sensor can detect such an object at that range…
Hey David,
See my comments below.
What is the maximum detection range, and over what distance can it provide accurate range measurements?
[EV] Checkout the mmwave estimator tool where you can properly tune the radar to maximize for certain performance…
Hi, MAX_VEL_ENH_PROCESSING - "Maximum Velocity Enhanced" processing path, used for the MRR80 subframe (80m medium range). This path applies special techniques to extend the maximum detectable velocity beyond what a single chirp design would allow (by…