Part Number: BQ24133
Tool/software:
Hi. I use a BQ24133RGYR for a 4V2 li-io battery cell,I enter with a DC-DC that regulate +5V from a +24V and I have some questions. *is ok the solution with only one input mosfet to prevent current from flowing back to…
Part Number: ISOW7841 Tool/software: Dear TI Support,
I would like to request a private contact from TI for EMC review of a design with ISOW7841.
BR
Balazs Kim
Hi Kapil,
Thanks for your patience.
The current booster could be a push-pull structure. You may find some if you search "gate driver current booster". We may want one with very low input current and sufficient output current to drive the LED.…
Shashank K S said: 3) Peak operating is 6A. Hence 8A is chosen as a limit
Then 8A limit is good.
Shashank K S said: 4) Should I add gate resistors for both the MOSFETs Q2, Q3?
In general adding gate resistance is better choice.
Best Regards, Arush
In the TI specified case below, it is showing 3.3V→3.3V or 5V→5V and taking the LDO into account so that the final output volatge is afetr the LDO...5V regulated. The TI spec takes the entire SN6501 design into account (including the LDO)
…
Hi Zhang,
Thanks for the additional information. I see there is some additional capacitors on the circuit which I had not seen before. Is there anything after these capacitors which connect to U39 output?
Figure 1 is confusing. Why change pin 4 voltage…
Part Number: TDP158 Tool/software: Hi Team,
Greeting.
We have used the TDP158RSBT in our design.
Kindly requesting for the design review.
Thankyou,
Nagendra Prasad [Engineer - Electronics]
Nash Tech Labs.
Part Number: CC2745R10-Q1 Tool/software: Dear Experts，
The following is the schematic diagram of CC2745.
Please help review whether the peripheral schematic design and ANT schematic design of CC2745 need to be optimized. Additionally, we have some questions…
