Part Number: SN65LVEP11 Tool/software: Datasheet for this component specifies that an LVDS signal input is an option but doesn't provide any input requirements for that LVDS mode. Are these LVDS input requirements available for this component?
Part Number: SN65LVEP11 Other Parts Discussed in Thread: SN65EL11 , CLC006 , LMH0002 Tool/software: I'm looking for a part with SN65LVEP11 but with a 1400mVpp amplitude instead of 800mVpp. The only constraint is that I need the rise time to stay the same…
Part Number: SN65LVEP11 Hi experts,
Greetings,
Now my customer is seeking for a very high frequency buffer chip. They found that SN65LVEP11 could be the potential candidate for this application.
however, their input for SN65LVEP11 is a signal with…
Lalit
Have you tried to remove R98 and R89, change R106, R105, R115, R116 to 50ohm, and add another resistor between R15/116 and GND?
The resistance is calculated as
R = Vcm / ((VOH+VOL)*0.5 - Vcm)/25)
Vcm = 0.5V
VOH = 1.425V
VOL = 0.759V…
Part Number: SN65LVEP11 Other Parts Discussed in Thread: SN65LVDS101 , , DS15BR401 Hi all,
I have a customer that is wondering if the following parts will be available in longterm
SN65LVDS101
SN65LVEP11
DS15BR401 (they prefer DS15BR401TSQ due…
Other Parts Discussed in Thread: SN65LVEP11 Hello,
In the data sheet of SN65LVEP11 data sheet P.3 , there is "PECL DC CHARACTERISTICS (Vcc=2.5V, Vee=0.0V).
And there are VIH(single-ended) and VIL(single-ended).
However, there is "Single ended…
Eli,
Please look at the SN65LVEP11 device from TI. It is very similar to the ON Semi NB4N11M.
SN65LVEP11: http://www.ti.com/product/sn65lvep11
Thanks,
Atul Patel
Texas Instruments
You can recommend CDCLVP1102 for the 1:2 fanout buffer since it has much lower additive jitter than SN65LVEP11.
Here are my comments on the schematics of LMK04828:
- On outputs where LVDS signaling level is desired, it is better to configure outputs…
