Hi Diego,
Regarding the IBIS model issues, I think this is a case of just having the correct pin definitions that ADS is expecting. I'm not immediately familiar enough with IBIS to tell you exactly what needs to be changed, but I also see that SN65MLVD206…
Part Number: SN65MLVD206B Other Parts Discussed in Thread: SN65MLVD206 Hi Expert,
The datasheet of SN65MLVD206B said it is an Improved Alternatives to SN65MLVD206, but 206B only features higher ESD level, other specs like trasceiver latency is worse than…
Part Number: SN65MLVD206 Other Parts Discussed in Thread: SN65MLVD040 , Hi Dear expert,
If SN65LMVD206 and SN65MLVD040 are in the same bus, will there be problem that these two MLVD transceivers has matching issue? We have concern these two devices are…
Part Number: SN65MLVD206 hi dear supporting team,
customer want to use one SN65MLVD206 driver to drive multiple SN65MLVD206 receiver, the clk rate is 8kHz, how many SN65MLVD206 is allowed as the loading? tks a lot!
Part Number: SN65MLVD206 hi dear supporting team,
for 206, there is below information in the package information, from my understanding, 725mW is only the max power consumption allowed for the D8 package in25degree , right? the actual max power consumption…
Part Number: SN65MLVD206 Hi! I try to evaluate SEE intensity of this device using IRPP method, so, could somebody clarify X, Y, and Z bit for RPP dimensions for this device, requirable for CREME-96 running?
Part Number: SN65MLVD206
Hi Dear expert,
If SN65MLVD206 isn't provided power supply, but there is input signal to device, will it break device? If not, can you please explain why it will break the part?
thanks very much!
BR,
Joyce
Part Number: SN65MLVD206 Hi Supporter
My customer has below scenario and want to adopt SN65MLVD206. Please help check if it is ok.
They need to transfer 1pps signal between two boards. One piece SN65MLVD206 on each board. Two boards are connected by 10m…
Part Number: SN65MLVD206 Hi
My customer is using SN65MLVD206 IBIS model. For the REC/DRVR_BI model, gnd_clamp doesn't go through zero point as below shows. What is the reason? Thanks!
Regards
David
