Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: Hello TI,
We plan to use this recommended LC filter (10uH+0.47uF) as suggested in below ticket:
https://e2e.ti.com/support/audio-group/audio/f/audio-forum/1436383/tas2505…
Part Number: TAS2505-Q1 Hi Ivan,
Our customer has some confusion about the datasheet.
The DVDD supply recommended value is 1.65~1.95v.
But on the power supply recommendations; digital core power range from 1.26v to 1.95V
My customer have some…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: Hi team,
I would like to know how to setup the registers of TAS2505-Q1 for AEC(Acoustic Echo cancellation) purpose.
I think I need to set up the DOUT pin or alternative…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: Hi Team,
We would like to use TAS2505-Q1 as our audio amplifier and below is our requirements.
I want to check if TAS2505 can achieve 32step volume control? We used…
Part Number: TAS2505-Q1 Tool/software: Hi team,
I accidentally damaged the TAS2505-Q1 on my board, so I would like to double check the
over current behavior.
Q1. How long does it take to detecting over current to shutdown the output?
Q2. How much…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: When using the TAS2505 as a Class D-AMP, and while the TAS2505 is set as shown below* and no I2S input(BCLK/WCLK/MCLK/DIN are not inputted), the PWM signal is continuously…
Part Number: TAS2505-Q1 Tool/software: Hello,
Our customer plans to employ TAS2505-Q1 as actuator driver.
Here is question, what happen if apply back EMF to SPKP and M pins from actuator during power off a TAS2505-Q1.
Our expectation is that even…
Part Number: TAS2505-Q1 Hi team,
Could you advise the absolute maximum rating of TAS2505-Q1 SPKP and SPKM pin?
I don't think it is tolerate of short to 12V car battery correct?
If that is correct, Is there any recommended protection circuit to protect…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: Hi Team,
Customer want to make TAS2505 DOUT signal bypassing the DIN of I2S primary interface.
They used 1st example register setup in the SLAU472C reference guide, and…
Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Hi team,
My customer want to find a single ended output PA up to 2W output. I found most our new devices are differential output devices. I want to query if TAS2505 can support single…
