Part Number: TAS5414C-Q1 Hi,
Could tell me the values of LC filters which you would recommend for 2ohm load impedance with BTL mode ?
Best regard, Kato
Part Number: TAS5414C-Q1 Hi,
Could you please tell me the absolute maximum ratings for /FAULT pin which should be connected to 3V ~ 5.5V with the pull-up resistor ?
Best regards, Kato
Other Parts Discussed in Thread: TAS5414C-Q1 , TAS5424C-Q1 Hi,
I have a question about TAS5414C-Q1,TAS5424C-Q1 datasheet. Q: Are the second rows of Table 17 - 23 respective reset (default) values?
Best regareds, Akio Ito
Hello Gregg,
Thank you for comments.
About paralleling output, I could understand it with below e2e, and sloa196:design guide(1.12 Paralleling Outputs session).
https://e2e.ti.com/support/audio-group/audio/f/audio-forum/601381/tas5414c-q1-tas5414c-q1-power…
HI Gareth
this is the evm user guide for tas5414c
https://www.ti.com/lit/ug/slou359/slou359.pdf?ts=1673485835317&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FTAS5414C-Q1%253FkeyMatch%253DTAS5414%2BEVM
this should be able to help you.
thanks…
Other Parts Discussed in Thread: TAS5414C-Q1 Hi, Team,
I have a question for TAS5414C-Q1.
What I want to know are bellows.
Is it OK to put 1uF cap on A_BYP and D_BYP? (I know it's not recommended by datasheet.)
-I guess the reason is related with…
Other Parts Discussed in Thread: TAS5414C-Q1 Hi,
Could you please give us your advice although we would like to grasp in detail about the short circuit protection which is mentioned on page 18 of TAS5414C-Q1 data sheet ?
Q1. Condition which SCP works …
Other Parts Discussed in Thread: TAS5414C-Q1 Hi,
Could you please tell us the behavior of the overvoltage protection ? The sequence of overvoltage protection is shown as below. We believe that the /FAULT pin is low, the output after the LC filter is Hi-Z…
Other Parts Discussed in Thread: TAS5414C-Q1 , TAS5414A Hi,
Could you please tell us how to transition this device into Hi-Z mode when detecting an OV, UV, OC, OT, or dc fault ? We understand that the first is the mute, the next step is low-low state, the…
Hi,
Could you please tell us the value(min/max) of the DC detect threshold ? We understand that the DC detect threshold which is mentioned on page 32 of data sheet as the typical value is 1.6V(default), the DC detect threshold tolerance which is mentioned…