Part Number: TAS5611A Other Parts Discussed in Thread: TPA3221 Hello expert, I'm looking for D-amp that can achieve following requirement. ・Ch: 1ch BTL or 1ch PBTL ・PVDD: 24V ・Load: 2ohm or 4ohm ・Maximum output power: 150W peak(don't need to support 150W…
Part Number: PCM5101A Other Parts Discussed in Thread: TAS5611A Dear,
My customers is going to use PCM5101APWR, LM61CIZ/LFT2, TAS5611A for their new products.
They are following this doc of AN-2029 Handling and Process Recommendations ( http://www…
Other Parts Discussed in Thread: TAS5611 , TAS5611A , TAS5613A Hi,
Could you please tell us the difference between TAS5611 and TAS5611A?
Best Regards, Kato
Part Number: TAS5611A Other Parts Discussed in Thread: TAS5611 We are using the TAS5611A (X2 to drive a dual voice coil driver, 2ohms per coil) & we have based the design on TI’s Typical Differential (2N) PBTL application with BD Modulation filters (also…
Hi Sean,
AC coupling is highly recommended with the TAS5611A.
The common mode voltage on the input pins ramps during startup. Although the VI_CM pin ideally ramps with the common mode voltage of the input pins, this voltage reference can be very sensitive…
Other Parts Discussed in Thread: TAS5611A , TAS5611 , TAS5630B , TAS5613A What happens when TAS5611A is driven to it's extends and at some frequencies the load impedance drops below 3 Ohms while no Schottky diodes are present from OUT_x to GND?
Can…
Hello,
Exceeding the analog input voltage swing will cause the input ESD diodes to conduct. Since these diodes are designed to handle low current ESD events the risk of failure is high. Since didoes often fail as a short, this will short the input…
Other Parts Discussed in Thread: TAS5611A , TAS5615 , TAS5630 Hi
I make work a free sample of TAS5611a on my own PCB in BTL mode, I need to test the efficiency, then I use as a input signal a sinusoidal signal 1kHz of frequency, the same signal for…
Other Parts Discussed in Thread: TAS5611A Helow
The capacitors C10, C12, C14 y C16 in the datasheet are polarized different than C14, C15, C16 and C17 in the EVM guide. Which is it right?.
Thanks
Andres P
Other Parts Discussed in Thread: TAS5611A , TAS5630B I want to use the TAS5611A in the 2.1 configuration (mode bits M[3:1] == 011, 1 × BTL +2 ×SE). But I can't find in the datasheet which inputs A-D are used for the BTL channel, and which are used for…
