Hi, John,
Welcome to e2e, and thanks for your interest in our devices.
Please review the section titled "Parallel Bridge Tied Load Mode Select (PBTL/SCL Pin)" in the TAS5760MD data sheet on page 37. Let me know if you have questions after you review this…
Hi, JaePhil,
We did not specify the dynamic range of this device, but 84 dB should definitely be achievable.
FYI, this is a very old device. We have newer better parts. Is it too late to evaluate one of our newer generation products? For example, we have…
Hi, Ali,
The TAS5727 is an open loop amplifier, so the PSRR is not great (I've asked my colleague to comment on that).
You would be better suited to use a closed-loop amplifier like our new TAS5760MD or TAS5760M.This will have much higher PSRR.
-…
Hi, Paulo,
The TAS5710 is quite an old product. I'd suggest you look at one of our newer devices.
For the TAS5710, you have to have an inductor on each output, and then you connect the PBTL after the inductors.
If you look at one of our newer products…
Other Parts Discussed in Thread: TAS5704 , TAS5760M , TAS5760MD Hi,
Does someone have the reference design for PBTL output with TAS5704 under the condition as below?
PBTL output、Vcc=12V、RL=4Ω、Output Power =20W
or Is it possible to configer the TAS5704…
Other Parts Discussed in Thread: TAS5766M , TAS5766MDCAEVM Dear all, I have 2 qestions,especially in TAS5766 register setting,need your support ,thanks~ 1.after read TAS576x technique document(TAS576xM 2x50W/4Ω PurePath Smart Amp) ,except Analog gain…
Other Parts Discussed in Thread: TAS5760M Hi,
I can not figure out the clock problem with my TAS5760M DAP-32 amplifier IC. It always report a clock error from the register. I am driving my I2S signal from a AIC3254 Codec in I2S format. I am using a fs…