Part Number: TAS6424-Q1 Other Parts Discussed in Thread: TAS6424 Tool/software:
When we use TAS6424, there is an output without sound, and the waveform is as shown above. What may be the reason for this? And what are the solutions?
The waveform measured…
Part Number: TAS6424E-Q1 Other Parts Discussed in Thread: TAS6424 Tool/software: Hi Team,
Customer FAW wants to have FIT, FMD and Pin FMA FuSa docs, could you help to provide it?
And if you have the docs for TAS6421, please also help to provide.
BR,
…
Part Number: TAS6424-Q1 Other Parts Discussed in Thread: TAS6424
Tool/software:
Hi,
I need to develop driver for TAS6424. Can anyone assist in providing a non-GPL RTOS driver reference.
Thanks in advance
Markand
Part Number: TAS6424E-Q1 Tool/software: Hi team,
Could you please advise the capability of I2C Random/Sequential Access especially for "Read clear register" for the devices below?
I found TAS6584 fault memory registers are not Read Cleared…
Part Number: TAS6424E-Q1 Hello,
During the use of the TAS6424EQDKQRQ1 digital power amplifier, there is significant interference to the radio signal. Do you have any good suggestions or recommended solutions?
Thanks!
Part Number: TAS6424-Q1 We're using TAS6424-Q1 Audio Amplifier IC in our design. We need to know the power consumption of all channels during audio playback when operating at 4ohm and 20W on each channel in the worst-case scenario. We have analyzed…
Part Number: TAS6424E-Q1 Other Parts Discussed in Thread: TAS6424-Q1
Tool/software:
Hi There,
I have connected two tweeter(4 ohm, 4 ohm) parallels to two speaker(4 ohm, 4ohm) to channel1 and Channels2 of tas6424-q1. Reading the impedance values from the…
Hi
JHENG-WEI WU said: About Q2&Q3, please let me sharpen my question: The only way to trigger DC load Diag. is (1) channel state in register 0x0F must be 01:Hi-Z. (2) write register 0x04 in specific channel's bits to 00:PLAY or 10:MUTE. Is that correct…
Part Number: TAS6424E-Q1 Tool/software: 1 .Does it support 1ohm 80W in PBTL mode,and if there is some potential risk about other specification?
2. Spread spectrum 8% is PWM ±8% or±4%?