Hi Wyatt,
I have attached some picture of the current profile that we are trying to measure. The load is an electric fence and the charging is done by solar panel. The reason for running the test of 4 hours of load and then a short charge at 500mA is…
Hi Clayton,
How are you?
Thanks for using ADS5263EVM.
We are using TSW1400 EVM to capture the LVDS output data from ADS5263EVM.
Because our GUI only supports this TSW1400EVM to capture the output data from ADS5263.
This TSW1400EVM is using FPGA…
7360.TSW1400_D_SCH.pdf
Hi Gauthier,
Thank you for detail information.
The ADS5263 EVM is running with a data capture card TSW1400 EVM
(because LVDS signals' Timing is a big crucial.)
which is using Intel (used to be Altera) EP4SGX70 FPGA unit…
You are quoting the TRM. I was talking about the Datasheet. The link on the product page is missing at the moment, I suppose a new datasheet will be available today or tomorrow. I'm attaching the last available version:
am335x DM_Rev.H.pdf
Part Number: LMX2581 Other Parts Discussed in Thread: LMK00308 Hi,
I would like to drive lmx2581 using lmk00308. Is it good to add clock buffer to convert differential to single ended or using reference design from EVM ?
If second option is preferred…
Dear Kuramochi-san,
the I2C specification (which is industry spec) is clear about ACK and NACK condition
for example, in your scenario #1 above, you are asking about the slave not ACK'ing the master sending address byte. (NACK)
this would result…
Hi Ammar,
Yes,If we turned off notification then connect devices connections are stable with 3-4 connections also. But when some data transfer going on we are getting connection failed.
Please check below sniffer logs with 2 connections. If we increase…
Part Number: TLV320AIC3109-Q1 Hello
I am using TLV320AIC3109-Q1 in my system and while reading datasheet I have found some mistakes in datasheet.
In datasheet register map table (Table 8. TLV320AIC3109-Q1 Register Map) and its detail are not same…
Hi Yakov,
This depends on how you packetize that particular UDP data. The FW on the DCA should be able to understand the command sent. If you can send the same commands over UDP directly (I believe this format is mentioned in the DCA1000 developers…
