Part Number: TL331-EP Tool/software: Hi,
In one of the application, TL331MDBVTEP will be operated as shown below during startup condition.
Output of U1 is pulled up to 20V. Vcc pin of U1 is floating. As per simulation, U1 output is measured as LOW…
Part Number: TL331-EP Hi there,
Please could you inform me about terminal finish of the part TL331MDBVTEP. Could you tell me the thickness of Au in case the terminal finish is NiPdAu or NiAu or Au.
Thanks.
Best Regards, Kaoutar Ben Kaddour
Part Number: TL331-EP Other Parts Discussed in Thread: TL331 I have a customer using the TLV331-EP in the following config:
As you can see below, output is low when non-inverting input exceeds the value on inverting input at startup.
Any insight…
Part Number: TL331-EP Other Parts Discussed in Thread: TINA-TI , , TL331 , TLV3401 , TLV1701 , TLV3011-EP , LM193 , LM139 , LM293-EP Tool/software: TINA-TI or Spice Models Hi,
I am using TL331-EP for my design. I have downloaded Pspice model from TI…
Other Parts Discussed in Thread: TL331-EP After completing a design it was found that the absolute maximum ratings on the TL331-EP comparator were being exceeded in 2 operation modes for the system. The maximum rating lists the input voltage for V+ or…
Hi Asha,
2. Please note that even though TL331-EP has an extended temperature range when compared to the TL331LV, they are not the same spec. TL331LV is rail-to-rail input has an input common mode voltage range of 0V to VCC, while TL331-EP has an input…
Part Number: CD4504B-EP Other Parts Discussed in Thread: LM293-EP , TLC372-EP , TL331-EP , LM239A-EP Could you please confirm if CD4504BMPWREP can be used for 15V to 3.3V level down shifting.
Under recommended condition , i see 5V as minimum input voltage…
Part Number: TL331 Other Parts Discussed in Thread: , LM393A , LM393 Hi, I want to use a TL331-EP to cut off slowly falling flanks. The Design is as follows:
The problem is, as soon as the non-inverting input (signal in) reaches around 3V there's…
