Answered

• TL7726: Using the TL7726 to protect differential inputs for Audio amplifier, how the handle the virtual ground.

  

  Jaye Waas

  Resolved

  Part Number: TL7726 How should the TL7726 be connected to a differential input circuit using bipolar power supply? For instance , what/how should the TL7726 Clamp be connected to the differential inputs and what should the Gnd be connected to? Yes it…

  • Resolved

  • 5 months ago
  • Power management
  • Power management forum

• TL7726: Capacitance of CLAMP pin(s)

  

  Ted Casper

  TI Thinks Resolved

  Part Number: TL7726 What is the capacitance of the CLAMP pin(s) for the TL7726. Is this 10s of pF, 100s of pF, nF, other?

  • over 2 years ago
  • Power management
  • Power management forum

• TL7726: Do we have quicker alternative which doesn't cut of the flanks?

  

  Florian Luetkebohle

  TI Thinks Resolved

  Part Number: TL7726 Hi, my customer is looking for an alternative to TL7726 which acts quicker and doesn't influence flanks. Best regards, Florian

  • over 6 years ago
  • Power management
  • Power management forum

• RE: Increase output drive by adding push/pull

  

  Ron Michallick

  Steven, The obvious choice is to change the op amp supply voltages. There is also TL7726 hex clamp. Some specifics for the clamp voltages would be helpful.

  • over 5 years ago
  • Amplifiers
  • Amplifiers forum
Answered

• OPA313: How to choose the Vshunt in low side bidirectional current sensing

  

  Victoria Qin

  Resolved

  Part Number: OPA313 Other Parts Discussed in Thread: LM324-N , TL7726 Hi, Low-side, bidirectional current-sensing circuit | TI.com Video In this training video, I feel confused about the reason to choose Vshunt maximum as 100mV, and also confused…

  • Resolved

  • over 3 years ago
  • Amplifiers
  • Amplifiers forum
Answered

• Input protection like TMUX13xx

  

  richard armitage

  Resolved

  Other Parts Discussed in Thread: TMUX1309-Q1 , TMUX1308-Q1 , TL7726 What other devices have the remarkable built in protection like TMUX13xx? Avoids shunting fault current into supply line? Is there just that for an input protected no multiplexor attached…

  • Resolved

  • over 4 years ago
  • Interface
  • Interface forum

• RE: TLV4170: High input current when used for active clamping

  

  Ron Michallick

  Aditya, If 5V is the supply voltage, try TLV9064 instead. If multiple clamps are needed, here is TL7726 Hex clamping IC

  • over 6 years ago
  • Amplifiers
  • Amplifiers forum
Answered

• RE: LMR33620: LMR33620

  

  user744376

  Resolved

  Hi Andy, Thank you for your promt reply. See the attached: SLYA014A - May 2000 Latch-Up, ESD, and Other Phenomena Please if possible contact the Chip Designer and let me know how many mA the that can be accepted into the the FB pin without this…

  • over 6 years ago
  • Power management
  • Power management forum

Didn't find what you are looking for? Post a new question.