Other Parts Discussed in Thread: TLC071 1. I am presently using op-amp tlc071.the problem with this op-amp is this that when it is being biased by +/- 5V power supply it is getting heated. As this is a single power supply op-amp but by using dual power…
Hey Jonathan,
Quick note here, the TLC071 has a higher output current but the max supply voltage is lower, and will not work at +/-15V. Have you considered the OPAx990 family of devices? It's a much newer device, with 80mA of output current and can be…
Other Parts Discussed in Thread: TLC071 , TLC072 , OPA1642 , OPA172 , OPA827 , OPA1688 Hello,
I am designing a new audiometer (for hearing testing) and our old design uses the TLC072 and TLC071 amplifiers in the output stage of the audio. I am wondering if…
Other Parts Discussed in Thread: MSP430F235 , TLC071 , TLV822 1. I want to interface output of op-amp tlc071 with adc12 of msp430f235. the maximum current at any pin of msp430 could be 2mA. but tlc071 supplies current more than 2mA. In order to prevent microcontroller…
Other Parts Discussed in Thread: TLC071 Hello,
I designed a filter using TLC071 because it is supposed to work with a single power supply , but the op amp just works when connected to two power supply. Is there anything I am missing?
Thanks
Other Parts Discussed in Thread: TLC071 1. For op-amp tlc071 typical value of output current is 57 mA (given in the datasheet). Now how to decide this given current is for which value of load resistence because ultimately output current of op-amp will…
Akhilesh,
It certainly common to connect the ground of the battery to the oscilloscope ground. But this is not necessary. There might be some other circuit node at which you could connect the oscilloscope. It should, however, be a low impedance node.…
