Answered

• TLC339: Technical Assistance Required ------ P/N: TLC339IDR

  

  Usman Niazi

  Resolved

  Part Number: TLC339 Tool/software: Hello Team, I hope you are doing good. One of our customers purchased 100 units of TLC339IDR and requested 8D report with following complaint. --------------- We have identified 10 defective ICs on our HP3070…

  • Resolved

  • 4 months ago
  • Data converters
  • Data converters forum
Answered

• TLC339: ESD Rating

  

  Carlo

  Resolved

  Part Number: TLC339 Hi team, Good day. Our customer would like to know the HBM, CDM and MM ESD rating for the following devices: LM6511IMX NOPB TLC339IDR TLC339IPWR TLC3704IPWR TLC393IDR Thank you in advance…

  • Resolved

  • over 5 years ago
  • Amplifiers
  • Amplifiers forum

• TLC339: The pulse was extended without reason from the input comparator to the output

  

  Shai Richter

  TI Thinks Resolved

  Part Number: TLC339 The pulse was extended without reason from the input comparator to the output (8msec pulse from the input has prolonged to 44 msec at the output). Is there any answer/reason for that? Recently, our system was failed because of…

  • over 4 years ago
  • Amplifiers
  • Amplifiers forum
Answered

• TLC339: Question regarding the reason for adding a DC source at the output of this comparator in this reference design.

  

  A BC

  Resolved

  Part Number: TLC339 Hello, I am looking at the circuit on page 50 of this presentation ( Microsoft PowerPoint - Sec2_RemoteSysMonitor_Print.ppt (ti.com) ). I am unable to understand the reason for use of this battery and the 2k resistor here. Would really…

  • Resolved

  • over 4 years ago
  • Amplifiers
  • Amplifiers forum

• TLC339: clamp current of the comparator

  

  GEO FRANCIS

  TI Thinks Resolved

  Part Number: TLC339 I am using TLC339 comparator in one of our circuit with the VCC=3.3V and GND. I have attached the schematic. The input is a square wave with frequency of 100Hz and amplitude is +/- 15V. When the input is -15V the diode will be forward…

  • over 8 years ago
  • Amplifiers
  • Amplifiers forum

• Re: Parisite capacitor input for TLC339 and TLC374

  

  Neil Albaugh

  Tom; Yes, it is important and the input capacitance should be in the data sheet as well as in the device macromodel.

  • over 13 years ago
  • Amplifiers
  • Amplifiers forum

• TLC339 drain pull-up

  

  Thomas Kuehl

  Other Parts Discussed in Thread: TLC339 This question is being posted for an FAE: For TLC339, I have a question: If the VDD is powered by 5V and we have got a pullup resistor on the comparator output pin that is pulled up to 3.3V. Is that OK? Does…

  • over 15 years ago
  • Amplifiers
  • Amplifiers forum
Answered

• LM139A: Temperature drift characteristics of the LM139A

  

  Josel Go

  Resolved

  Part Number: LM139A Other Parts Discussed in Thread: LMP7300 , LM2903B , LM2903 , TLC339 Hi Experts, Good day. Please help provide the temperature drift characteristics of the LM139A voltage comparator. Keep safe. Regards, Josel

  • Resolved

  • over 3 years ago
  • Amplifiers
  • Amplifiers forum

• SN74HCT04: SN74HCT04

  

  Elamurugan Palanisamy

  TI Thinks Resolved

  Part Number: SN74HCT04 Other Parts Discussed in Thread: LM393 , TLC339 , LM339 , TLC374 , TLV1704 , TLC354 , LM311 Hi Team., I have tested the below drive circuit, but its consuming more current if i give VCC to GND an Gnd to 5v. But if I connect VCCto…

  • over 3 years ago
  • Logic
  • Logic forum

• Re: Looking for Open drain Comparator

  

  Neil Albaugh

  Jung-Ho; Try a TLC339.

  • over 13 years ago
  • Amplifiers
  • Amplifiers forum

Didn't find what you are looking for? Post a new question.