Hi,
I tried to use the PSpice Model of this comparator but the result at the output pin is always near zero also when the non-inverting input is larger than the inverting input. More precisely I have 17mV when the inverting input is larger and a voltage…
Hi Mohana Krishnan,
Thanks for the question. The short circuit protection is also implemented by the overcurrent protection circuit(TLC372) - short-circuit is an extension of overcurrent and OVERLOAD signal is used to disable the gate drivers by pulling…
Part Number: TLC372M Other Parts Discussed in Thread: TLC372 , LM158 Hi Sir,
The TLC372 pspice model avilable in TI website is not giving output.
I have attached the DSN file, why this comparator simulaton is not giving output.
regards,
Nesh
Part Number: TLV3402 Other Parts Discussed in Thread: LM2903 , TLC372 Hi, my customer's schematic is as below: U2 is TLV3402.
The waveform of pin 2- yellow, pin 3- green, pin1-blue are shown below:
As we can see, pin2(IN-) is always higher than pin3…
Part Number: TIDA-00366 Other Parts Discussed in Thread: AMC1301 , OPA320 , TLC372 , UCC21520 Hello!
According to the schematic of TIDA-00366, at the starting point it's clear that bootstrap capacitors aren't charged.
So AMC1301 IC's used for three…
Part Number: TIDA-00366
Hello!
According to the schematic of TIDA-00366 , at the starting point it's clear that bootstrap capacitors aren't charged.
So AMC1301 IC's used for three-phase current sensing are not supplied because their VDD1 are supplied…
Part Number: TIDA-00366 Other Parts Discussed in Thread: UCC21520 , TIDA-00199 Hello,
According to the schematic of TIDA-00366 , at the starting point it's clear that bootstrap capacitors aren't charged.
So AMC1301 IC's used for three-phase current…
Other Parts Discussed in Thread: LMV393 , TLV1702 , TLC352 , TLC372 , LM393 The output of the LMV393 is open collector, but the datasheet recommends that the output voltage be Vcc + 0.3V Max.
I am looking to pull up the output to 12V. Can I do that?
Other Parts Discussed in Thread: LM2903-Q1 , LM2903 , TLC372-EP Hello,
I understand that the absolute Max rating of LM2903-Q1's input voltage is -0.3 V on the negative voltage side. However, I'm wondering whether -1 V is tolerable if the current that flows…