Hello Nitish,
It should recover to normal operation, but it may take a few more microseconds - longer than the normal propagation delay.
Is this a DC voltage? Or an AC signal or pulse? Are there any transients on the supply or output?
There are…
Hello,
Thanks for your prompt reply. I use TI part number : UCC2895, UCC27324, TLC272, TLC393 . . .
These are waveforms :
Vmain_trafo = primary voltage waveform
Vsec_trafo I = secondary voltage waveform (measured direct to the secondary…
Other Parts Discussed in Thread: TMS320C6745 , TLC393 Hi,
Am using my custom board TMS320C6745 with XDS 100 USB V1 EMULATOR , all my boards are working except one kit . so i sure about software, gel file, my design are all good at working condition…
Part Number: LM111QML Other Parts Discussed in Thread: LM111 Tool/software: Hi TI team,
We have been conducting offset voltage test for the LM111JG comparator using the Single Auxiliary op amp servo loop method in a bench setup. The testing is performed…
Other Parts Discussed in Thread: TLV3402 , TLC393 Team,
Customer is using the TLV3402 and is seeing a log propagation delay from High to Low when the input is dropping slowly. They mention 2msec. Is this normal and if so do you have a better part that…
Other Parts Discussed in Thread: TLC393 , TLC339 , TLC193 , TLC372 , TLC139 1. I have an application where I have to drive N-channel MOSFET depending upon signal from MSP430. Since MSP430 alone cannot drive the FETS, So I have put to op-amp between MSP430…
Hi,
Thanks alot.
I try to make it for our University, so it must be complete. I added three NOT gate According to XDS100 map and I use ADUM1200 for EMU0 & EMU0 pin isolation and I removed 74HC74, TLC393, MCP6041. I think it must be true. I want to…
