Part Number: TLC5971 Tool/software: Hello,
I am designing a board that uses a TLC5971 to light LEDs.
I put the SPI signal from the input connector into the SDTI and SCKI of the TLC5971, connected a 22 ohm resistor in series with each of the SDTO and…
Part Number: TLC5971 Other Parts Discussed in Thread: LP5012 I am developing with TI TLC5971PWPR LED driver and am using it to control 4 separate RGB's on my battery powered device. My device has a function where it enters low energy mode but the LED…
Part Number: TLC5971 Other Parts Discussed in Thread: , TLC5973 , TLC59731 Hi, we need your technical support for our new electronic design with the TI TLC5971/TLC59711.
Please could you confirm us capability of this chip for theses specific pins interconnections…
Part Number: TLC5971 Other Parts Discussed in Thread: TLC5948A , TLC5943 Hi
Could you help recommend Driver IC
The product is a penetrating screen, so the layout space is very small, and the layout of TLC5971 needs to be relatively large, so please recommend…
Part Number: TLC5971 Hello
I wanted to know if BLANK is held low can this part support 100% duty cycle output (non-modulated output) if GSRef clock is set to 65536
Venkat
Part Number: TLC5971 I am designing a single-layer board with the TLC5971RGE and am wondering if I can connect the NC pins (3, 4, 14, 17) to GND to have a better GND connection to the Thermal Pad?
The datasheet says these pins have no internal connection…
Hey Steven,
We went ahead and did an initial placement of our PCB. Please find it attached. The main question I am dealing with is this:
Should we speared the TLC5971 devices evenly as possible (each device behind every 12 leds) and by that create short…
Part Number: TLC59711 Other Parts Discussed in Thread: TLC5971 , Team,
TLC59711 and TLC5971 (HTSSOP-20) seems to be very close (same package, same pinout): www.ti.com/.../compare.html
I have found the below post but it does not give 100% the confidence that…