Part Number: TLC6C5712-Q1 Tool/software: Dear Team,
I am currently using the TLC6C5712-Q1 12-Channel LED driver in my project and have encountered an issue withdiagnosing the feedback of the Tell-Tale (TT) indicators. Specifically, when the TT is in…
Part Number: TLC6C5712-Q1 Hi,
The customer has questions about TLC6C5712-Q1.
The purpose is to optimize the number of connecting pins between the MCU and the LED DRIVER.
Can I open the PWM0-5 PIN?
The system requirements are as follows and please check…
Part Number: TLC6C5712-Q1 Other Parts Discussed in Thread: TLC6C5748-Q1 , TLC6C5724-Q1 Hi,
The customer is looking for an LED driver for SBW.
Can the TLC6C5712-Q1 be LED driven with a 200Hz frequency?
Please recommend it based on the specifications.
…
Part Number: TLC6C5712-Q1 Hi team,
I'm working on a schematic circuit design with the TLC6C5712-Q1 and LW T6SH.CB-CZEY-FK0PM0-Z664-50-R18-Z leds (If=50mA @ Vf=2,9V). If I power up the leds with a 5V source, can I connect the leds directly to the output…
Part Number: TLC6C5712-Q1 Hi expert,
I saw datasheet shows Vo=0.7V result. When Vo was increased to 1V, would the code to current accuracy keeps the same with Vo=0.7V?
Thanks.
Part Number: TLC6C5712-Q1 Hello Expert,
I have question about IREF, LATCH, PWMx, SCK, SDI pin's recommended operating range and absolute maximum rating.
Those pin's absolute maximum rating is Vcc but recommended operating range is 5.5V. It seems…
Part Number: TLC6C5712-Q1 Hi team,
Could you advise if POR_ERR_FLAG register (default = 1h) is clear by READ?
It set to 1h at Vcc start up or after software reset. This is read only register, so I would like to know if the register value is cleared by…
Part Number: TLC6C5712-Q1 Hello, Team,
Customer would like to share the SPI communication bus with other devices. We know that multiple 5712 can be connected to a same bus with a cascade connection, would it be able to:
a. With LATCH=H, communicate wi…
Part Number: TLC6C5712-Q1 Hello,
during an long test (around 12h) we detecd some short-to supply fault on the channels that happen when the channel is deactivated.
The fail is not persisted it disappear once the registers are read and cleared.
We tried…
