Search tips
Showing 52 results View by: Thread Post Sort by

  • INT- TLV3501 in low speed application

    Other Parts Discussed in Thread: TLV3501 , TL3016 , TLV3401 , TLV3701 , TL712 , LM306 , OPA836 what is the high speed performs regarding of low speed input ? In my understanding the output will be instable esp. near the threhold point. it is the second…

  • Building a simple circuit to detect electrical contact

    Other Parts Discussed in Thread: TLV3401 , TINA-TI Hello, I am trying to build a simple circuit that can detect whether a conductive nanoscale cantilever probe (basically, a sharp needle) is touching a bare Au substrate. Currently, I have used one of…
    • Answered

  • Re: LM339 as comparator

    Resolved
    Hi, I have now used two TLV3401. Below is the schematic: Problem is when no current flows U2 is high but U1 gives o/p low. I don't understand why this happens? I checked voltage at inv & non-inv terminal of U1, volatges are same. Then why…
    • Answered

  • Re: LMV331 Input Voltage Range (V_CM)

    Resolved
    HI Zachary, The common mode limit is an absolute for each pin, not the average of the two pins. The formula is correct, but not applicable... Comparators can have differential voltages of several volts, so one input does not get a "free-pass" because…
    • Answered

  • Low voltage signal amplification/conversion to go to a hi speed counter in a Contrologix PLC

    Resolved
    Other Parts Discussed in Thread: INA138 , TLV3401 , TLC372 , TLV3701 , TLV3012 , TLV3011 I have a sensor with supply voltage of 4.5 - 20 V cc , and and operating frequency of 1 - 2500 Hz and 100 ohms resistance. This signal we are currently reading (I…
    • Resolved
    • Answered

  • RE: TLV3402 latch-up

    Resolved
    Hi Alexander, I was traveling this past week and I am still catching up on email. It is difficult to know what the problem could be without having all the circuit details. They mention the inputs being about 500 mV apart and coming up with Vcc, but…
    • Answered

  • Amplifier and comparator question

    Resolved
    Other Parts Discussed in Thread: TLV3401 , TLV3701 Hi, just a little question from a non-hardware guy :) I would like to know your opinion and/or suggestion for the best TI products when considering: Low-power comparators. We are working with…
    • Resolved

  • Excessive current on 74AUP gates

    Other Parts Discussed in Thread: TLV3401 , SN74AUP1G14 , SN74AUP1G00 I presented this issue to TI support and they bailed out on me and suggested I use this forum to see if anyone could offer a suggestion or solution, I am about to try the TLV3401…
    • Answered

  • RE: LM2903B-Q1: Test Circuit for Propagation Delay Time

    Resolved
    Hi Shinichi, I think this is the test circuit: 2103 - Comparator Applications 3.pdf Kai
    • Answered

  • Re: 12vdc BATTERY LEVEL MONITOR

    Resolved
    It sounds like you want a comparator circuit that monitors the battery voltage and drives an LED. For the comparator, the TL331 is the most cost effective solution. For lower operating current (to prolong your battery life), I recommend the TLV3401. Either…

Didn't find what you are looking for? Post a new question.