Part Number: TLV9032-Q1 Hello TI-team,
using a TLV903x (push-pull comparator), it says in the absolute maximum ratings, that the voltage on the output should not exceed (V+) + 0.3V. But in the block diagram there are some body diodes of the FETs shown…
Part Number: TLV9032-Q1 Other Parts Discussed in Thread: TLV9032 , TLV9022 Tool/software: Hi TI,
I have an application in which the inputs of the TLV9032 will see a voltage higher than the supply voltage. Is it OK to clamp the input voltage with the…
Part Number: LM2903-Q1 Other Parts Discussed in Thread: TLV9032-Q1 , Hi,
The customer will check the link below and ask questions.
https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1039478/lm2903-during-power-on-what-is-the…
Hi Muwei,
The newer push-pull version of the LM393LV-Q1 is the TLV9032-Q1 .
TLV7032-Q1 and TLV1812-Q1 are good options if you would like to trade some speed for lower power.
What is the higher propagation delay that is acceptable for your end…
Part Number: TLV9022-Q1 Other Parts Discussed in Thread: TLV9032-Q1 Dear TI team,
I using comparator TLV9022QPWRQ1 for comparing input sine wave (up to 200 kHz) with constant DC signal. I found that this comparator is working properly till 30 kHz input…
Part Number: TLV9032 Hi TI,
Looking at the datasheet (the version found here at least: https://www.ti.com/lit/ds/symlink/tlv9032-q1.pdf ) I noticed that table 6.6 and table 6.8 appear to be identical except for two PSRR entries in table 6.8 which…
Part Number: SN74LVC2G08-Q1 Other Parts Discussed in Thread: TLV9032-Q1 I am looking for pin drop replacement for my existing part 74HC2G08DC-Q100 (NEXPERIA) in one of my design. At present i am using it for just driving transistor base with 100k and…
Part Number: TLV3202-Q1 Other Parts Discussed in Thread: TLV3202 , TLV9032 , TLV7032 , LM393LV
Hi
below is the circuit, during test, TLV3202 is easy to be damaged, mainly focus on pin 3, when pin 7 output 5V, pin 3 is 1.69V or 3.72V, it is 5V for…
