Part Number: TMCS1108-Q1 Other Parts Discussed in Thread: TMCS1108 Tool/software: Hi team,
I want to know the max detection distance of TMCS1108-Q1. Now I want to use Hall sensor to detect cell phone's magnets. Do you have any better suggestion of TI…
Part Number: TMCS1108-Q1 Hello E2E Experts,
Good day.
I am using TMCS1108-Q1 current sensor IC. According to the datasheet the Vout equation I can't get proper output voltage at the Vout pin.
In this condition when my led strip, which I have connected…
Part Number: TMCS1108-Q1
Hello,
I am using TMCS1108A1U-Q1 IC to measure voltage as well as current in channel. According to my Design I have connected Current IC output to my 16-Bit Resolution ADC Channel. So, I have main issue with my current…
Part Number: TMCS1108-Q1 Hi Experts,
Our customer has this question:
"Characteristics warn about capacitance above 1 nanofarad on output (pin 7) for stability. If that is sensitive, what series resistance is enough to place a 0.1 uF after that resistance…
Part Number: TMCS1108 Other Parts Discussed in Thread: TMCS1101 Hello,
I'm building the footprint for this part and I would like to ask the creepage clearance to use because based on page 34 of datasheet there are two clearances. Usually in your datasheet…
Part Number: TMCS1108 Other Parts Discussed in Thread: INA226 , INA228 , INA226-Q1 , INA228-Q1 Tool/software: Hi,
I need to monitor vehicle voltages in the range of 10V to 16V using an MCU. Currently, I am using a resistor divider for testing purposes…
Hello Joe, Thank you for your reply.
Joe Vanacore said: By increasing the size of the pull-up resistor on the TMCS1123 OC pin, you will slow down the Low to High transition on the OC pin. Is this an option you have available?
Yes you are correct.…
