Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TMUX1122 Tool/software: WEBENCH® Design Tools I downloaded TMUX1122 PSPICE MODEL and tried to use it.
But there is a problem that does not work.
Please check if it does not work due to any problem.
Please check if there is a problem with…
Part Number: TMUX1122 Tool/software: WEBENCH® Design Tools Hi
I tried to run the simulation for the 2.0V voltage for the tmux1122 model, but I couldn't.
The reason is that the tmux1122 model only supports voltages from 4.9V to 5.1V.
I want to…
Part Number: PSPICE-FOR-TI Other Parts Discussed in Thread: TMUX8108 , TMUX8109 , TMUX1122 ,
Hi team,
One of our customer's issues, I'm forwarding it below, please give your comments if any.
It is currently expected to use TMUX1122, TMUX8108, TMUX8109…
Thank you,
your understanding was correct. But my processor 2 connects also to TCA9546APWR to fan out to other devices. Since TMUX1309 is not available and because TMUX1122 or 1121 are available, I can use 4 x TMUX1122/1121 to processor 1. I can add a…
Part Number: OPA858 Other Parts Discussed in Thread: TMUX1122 , TINA-TI Hello,
I am working at the software Pspice for TI, and I am designing a transimpedance circuit for photodiode sensing. My design demands many times of measure repeatedly (with a period…
Hi Alice,
We unfortunately do not have another pin-to-pin device as replacement, but we do have alternatives with similar function/performance.
I would suggest the TMUX1122 as another 1:1x2 channel alternative, however, this part does not have powered off…
Part Number: PGA460-Q1 Other Parts Discussed in Thread: PGA460 , ENERGIA , PGA460PSM-EVM , TS12A12511 , TMUX6119 , TMUX1121 , TMUX1122 , SN74LVC1G66
Hello,
I wanna use 2 transciever sensor that synchronous each other with PGA460-Q1. How can I do? Do I need 2…
When looking for an I3C analog switch / multiplexer it's important to understand some of the specifications of the I3C standard:
2-wire push-pull protocol
Voltage Levels: 1.2V, 1.8V and 3.3V
Frequency*: 12.5MHz max clock.
Max Bus Capacitance: 50pF…
Hi Bart,
the simplest analog only way I could come up with is the following block diagram:
Essentially, the Master can switch on/off all communication channels and the Slaves can choose to whom they want to send the signal.
For the multiplexers I would…
Other Parts Discussed in Thread: TMUX1309 The following table helps select th e right multiplexer and switch with Low Voltage VSIGNAL =< 24V in different configurations:
Precision , Protection , Automotive , General Purpose
Configuration
8:1
…
