Part Number: TPA2011D1 Hi Sirs, As title, my customer found the TPA2011 can send pop noise when asserting SD# from low to high with IN+ and IN- shorted together. Is the pop noise coming from output offset voltage? Do we have input offset voltage specification…
Part Number: TPA2011D1 Hi Sirs, As a following of the previous thread at https://e2e.ti.com/support/audio/f/audio-forum/974236/tpa2011d1-tpa2011-input-mixer-circuit-review We calculated the impedance matching after DC block capacitors: R9=R3//R6//R8//R6…
Part Number: TPA2011D1 Hi Sirs, Would you please assist us in reviewing the ground plans of Pseudo-Differential Inputs for TPA2011 amplifier. Our concepts are isolating noisy main ground plan and clean analog ground, provide better CMRR. Thank you and Best…
Part Number: TPA2011D1 Hi Sirs, We are supporting customer in designing a down mix circuit with TPA2011D1 as the picture below. There are three signal sources, PWM#1, PWM#2, and stereo analog audio, while they will not send signals simultaneously. A low pass…
Part Number: TPA2011D1 Hi team,
My customer wants to know the Rdson of TPA2011D1 but datasheet doesn't show this information, please could team help on this case?
Thanks a lot.
Vincent Chen
Part Number: TPA2011D1 Other Parts Discussed in Thread: PCM1754 , Hello team,
Does TI have Linux driver for TPA2011 ?
Is TPA2011 software-compatible to WM8524CGEDT from Cirrus?
Regards,
Itoh
Part Number: TPA2011D1 Other Parts Discussed in Thread: TPA2034D1 , TPA2037D1 Hello team,
My customer concerns about TPA2011D1 EN pop noise.
I don't find any specific description regarding the pop noise except for the introduction of the first page on…
Part Number: TPA2011D1 Other Parts Discussed in Thread: TAS2110 When EN is set high, device starts cycling, with a large current spike on VDD every 100 msec. It looks like it's drawing high inrush current, then short circuit shutdown and auto-recovery…
Part Number: LM48511 Other Parts Discussed in Thread: TPA2011D1 , TPA2013D1 Tool/software: 1. When was this device launched? Also, until when is supply guaranteed?
2. Are there any recommended replacement parts?