Part Number: TPA3110D2 HI!
I use the With PBTL Output and Single-Ended Input mode. In the TPA3110D2, after a logical "1" is applied to the SD input, the sound appears at the output of the microcircuit with a delay of more than 300ms. When using…
Part Number: TPA3110D2 Hi Team:
my customer use TPA3110D2 to output 4O5W by using 1S battery boost to 12V for PVCC, but we found that the device will mute after 450ms in sometime, does the I_rush will make the AMP in this fault status?
here attach the…
Part Number: TPA3110D2 Hi Team,
My customer need a PA, they used to use 3W but volume too small so they want to upgrade. Below are the key parameters,
Output power
~5W, mono
Power Supply
5V or 12V
Load
4Ωor 8Ω
Temp …
Part Number: TPA3110D2 Hi Expert,
Due to customer has board size limitation, can they just place one 100uf on PVCCR side, remove 100uf from PVCCL side, do you have any concern?
spec is 24V=PVDD, L=10W, R=10W
Regards,
Mark
Part Number: TPA3110D2-Q1 Hi team,
My customer use TPA3110D2-Q1 in their project. When the DC detect fault is triggered, the fault must be reset by cycling PVCC as shown in the datasheet.
But for the automotive applications, PVCC is always powered on a regular…
Part Number: TPA3110D2-Q1 Hi,
we are designing power amplifier for audio application. need following support,
1. Output power delivered to load in BTL configuration
2. Power dissipation by TPA3110D2-Q1
Regards
Amit Niungare
+91-7030930566
Part Number: TPA3110D2 Work voltage:26V
loudspeaker:20W 4Ω
volume:85%
The Loudspeaker stalled when playing some music.Like the 27.mp3.
The speaker stuck for 1 minute and 24 seconds of the music, then returned to normal after 400ms.
As can be seen…