Part Number: TPA6120A2 Tool/software: The TPA6120 oscillates easily if trying to drive headphones directly. The fix per the app note is to insert a resistor in series with the output of not less than 10 Ohms but in the data sheet reference circuits shown…
Part Number: TPA6120A2 Other Parts Discussed in Thread: TPS61093 I'm using a TPA6120A2RGYT as a headphone audio amplifier. The application is battery powered and I have a TPS61093DSKR generating +/-12V for the amplifier.
I've prototyped the amplifier…
Part Number: TPA6120A2 Hi Team,
My customer have a question about TPA6120A2.
The TPA6120A2 operates on single power supply with single end input. When A ferrite bead(300R/100MHZ ) are added to the output end , The quiescent current will reach 70MA (normal…
Part Number: TPA6120A2 Hello,
We plan to use TPA6120A2 at Gv=12dB differential input mode.
Rf=1kohm Ri=470ohm are planned setting.
Which is better to use "Tina TI" or "PSpice for TI" to optimize setting of noise and stability performance?…
Hello Dan,
I sent an update via email yesterday. Did you receive it? It included a zipped folder which might have been detected as a security concern.
Thank you,
Sima
Part Number: TPA6120A2 Hello!
I want to connect to the line output (maximum voltage peak-to-peak 2.7V) a headphone power amplifier on the TPA6120A2.
Can you please tell me how it can be connected to a mono input?
How to connect TPA6120A2 for single…
Part Number: TPA6120A2TPA6120A2 can be used for driving single ended speaker loads..? (In data sheet it is given for driving the stereo outputs but i need to drive the mono headphone speaker application).
Please provide the SPICE model for TPA6120A2…
Part Number: TPA6120A2 Other Parts Discussed in Thread: PCM5242 , PCM5142 hello, can you tell me where is the best place to insert a volume potentiometer?
regards
Gil
Part Number: TPA6120A2 We are planning to use TPA6120A2 device as audio driver to drive headphone with load impedance of 600 ohm to drive upto 500 mW.
To evaluate the device I have used 20 pin SOIC device and connected the resistors by referring datasheet…
