Part Number: TPS1HB35-Q1 Tool/software: Hello team,
I need to know maximum inrush current capability of TPS1HB35-Q1 if it need to handle a capacitive load in the range of 1128uF to 5280 uF.
Part Number: TPS1HB35-Q1 Tool/software: What is the maximum inrush current capability of TPS1HB35
Please provide inrush current capability of TPS1HB35 for a 47uF capacitive load , wire length 1m .
Part Number: TPS1HB35-Q1 Tool/software: Hello team,
Is ground separation mandatory? Can you explain why ground separation is needed with detailed application?
Best Regards,
Austin
Part Number: TPS1HB35-Q1 Tool/software: Hello,
Can the TPS1HB35X-Q1 family be operated at voltages greater than 28VDC on the Vbb pin? Looking at the data sheet is has a normal, extended low, and extended high operating mode. The clamping votlage on…
Part Number: TPS1HB35-Q1 Hello team,
we are using the TPS1HB35 for driving the capacitive and inductive load, Please can you share me the any calculation sheet or calculation tool if available
Part Number: TPS1HB35-Q1 Hello Team,
for EMI measurement my customer needs the frequency for the internal charge pump to drive the n-channel MOSFET. It's not specified in our datasheet but would be helpful.
Many Thanks
Josef
Part Number: TPS1HB35-Q1 Hi team:
My customer feedbacks that their E-call system use TPS1HB35A-Q1 has no output after enabling. Interestingly is that they firstly enable the device, and then connect the load, the output is also ok. But there will be…
Part Number: TPS1HB35-Q1 Hello, after the helpful recommendation in this thread: e2e.ti.com/.../tps1hb16-q1-capacitive-load-driving
I am now testing using TPS1HB35 C -Q1 in the circuit instead. It appears to be working well for this application, however…
Part Number: TPS1HB35-Q1 Hi support team,
TPS1HB35(A Version)'s Overcurrent Behavior is "Disable switch immediately".
If the Inrush current generated when starting with EN="High" is greater than the overcurrent detection value, will the overcurrent…
