Part Number: TPS25830-Q1 Other Parts Discussed in Thread: TPS25830A-Q1 Hi TI Team,
I am designing a USB Type-C interface using TPS25830-Q1 for the following application:
Segment: Passenger Car
Application: Cockpit Domain Controller / IVI
USB…
Part Number: TPS25830-Q1 Other Parts Discussed in Thread: TPS25831-Q1 , TPS25840-Q1 Hi everybody,
I am using a TPS25830-Q1 chip in the project i am working at. I would like to know more about the short to VBATT voltage event for the chip pins. The datasheet…
Part Number: TPS25830-Q1 Tool/software: Hi team，
Tier1：Harman
OEM: TATA
You know when VBUS short to battery , there will be tank ringing , do you know what the sustainable max voltage of each related pin is, in ringing case ? the ringing sustaining…
Part Number: TPS25830-Q1 Tool/software: Hi team,
Is there any way to guarantee that the chip can charge more than 10 watts to all mobile phones? The customer said that for some Huawei phones, due to some variation in D+ and D- levels, only 500mA of…
Part Number: TPS25830-Q1 Other Parts Discussed in Thread: TXS0104E-Q1 Tool/software: Hi Support team,
When TPS25830-Q1 the fault pin is pulled low, the maximum voltage is 250mV?
Since we are using the level shifter TXS0104E-Q1 connected to the MCU…
Part Number: TPS25830-Q1 Other Parts Discussed in Thread: TPS25830A-Q1 , Hi team，
TPS25830A-Q1 datasheet ：
TPS25830-Q1 datasheet ：
One description in TPS25830A and TPS25830 pulls up 2.2k, one dangling What would be the effect…
Part Number: TPS25830-Q1 Hello Team,
About TPS25830-Q1 current limit , we set current limit to 3.3A by setting R_limit to 11.82k, and work in typeC CDP mode.
But when set load to 3.7A, the BUS can work normally.
So why the output can't be disabled…
Part Number: TPS25830A-Q1 Other Parts Discussed in Thread: TPS25830-Q1 Tool/software: Hello Expert,
Our customer is considering to use TPS25830A-Q1.
As far as I confirmed, there is similar device whose name is TPS25830-Q1.
When I compared those…
Part Number: TPS25830-Q1 Tool/software: Hi team,
Could you teach me how to calculate eq(7) about R_ILIMIT.
Are these three parameter (R_SET, R_SNS, I_LIMIT) should use typical value?
Regards,
Youhei MIYAOKA
