Part Number: TPS54010 Other Parts Discussed in Thread: LM21215 Dear team,
Only maximum height is specified on the DS , could you please share nominal and tolerance as well as Theta_JC_Top et Theta_JC_Bot ?
Customer is using Two-Resistor Compact…
Part Number: TPS54010 Hi Sir:
I want to know about Switching frequency. Which is the best choice.RT contact Res or Open. which Fre Should be set.When I contact RES ,Do it mean use External frequency?
Part Number: TPS54010 Other Parts Discussed in Thread: TINA-TI Hi,
I found the TPS54010 pspice model on TI website. How do I import it into TINA-TI?
Best regards,
HC
Other Parts Discussed in Thread: TPS54010 I am working on a power design using TI parts. The customer is having some issues with noise so I was going to move them to a fully synchronized switcher setup using the TPS54010. The question I have is that the…
0.022 to to 0.1 uF is acceptable (see table on P. 5). Most of the reference designs use 0.047 uF. That datasheet is pretty old, and I know that some of the text is cut'n'paste from other even older data sheets. I think you are the only person to notice…
Other Parts Discussed in Thread: TPS54010-EP Hi,
I'm looking for a constant current driver that can power a laser diode at 10A with 2 Vf.
It must be powered by a Li-Ion battery.
Am I in the right path looking at TPS54010-EP??
Any help is appreciated…
Hello,
The UCC3806 is a dual output controller though it can be used in a flyback where only one of the outputs are used to drive the switch it might be better to choose a single output controller. Look at page 46 of the attached under General Purpose…
Siyu,
I think the toggle flip-flop in the block diagram on page one of the spec should have let you know that the max you will get with this device is 50% duty.
Go to page 43 and 44 of the attached and select a more suitable part.
