Other Parts Discussed in Thread: TPS54618-Q1 Hi,
Could you tell me about TPS54618-Q1 Fsw? Customers are using TPS54618-Q1 following conditions. ◇Vin=5V,Vout=1.2V,Iout=4A,RT=100kΩ Please tell me Max and Min of Fsw in this conditions. Best Regards, Yusuke…
Hi
I have a question about equation of RT resistor.
On the data sheet, it is shown at
However it is the following equation actually.
(This is the equation of TPS57114)
Which is correct?
Regards,
Koji Hamamoto
Part Number: TPS54618 Other Parts Discussed in Thread: TPS62816-Q1 , TPS54519 , TPS54678 , TPS54719 hi team:
my customer sourcing one device as below request, can you help to confirm and promote ? tks in advance.
1. p2p with TPS54618
2. I max load >5A …
Hi
Our customer are going to reduce the softstart time. ( < 1ms )
For example, Css=1000pF, Tss= (Min)0.29ms (Typ)0.4ms (Max)0.51ms (@Css+/-30%)
Is it possible?
We understand the short time softstart will make the the inrush current to output cap. …
Other Parts Discussed in Thread: TPS54618-Q1 Is it possible/acceptable to run the TPS54618-Q1 at a Vin = 6.5V "continuously"? The specification shows the ABS MAX for Vin = 7.0V and the "Operating Input Voltage" under "Electrical Characteristics…
Part Number: TPS54618C-Q1 Other Parts Discussed in Thread: TPS54618-Q1 , TPS54618 Hello.
I have tried to run a simulation using the given model on the product page, but I was not able to do it. I have tried using Pspice for TI and Pspice 17.2 and the results…
Other Parts Discussed in Thread: TPS54618EVM-606 , TPS54618-Q1 , TPS54618 Hi,
after some findings, i am planning to purchase the TPS54618EVM-606 for a project that we are currently testing.
our project is to produce a circuit that can variably change the…
Part Number: TPS43330A-Q1 Other Parts Discussed in Thread: TPS43330-Q1 , , TPS54618-Q1 , TPS54618 Hi Team,
What is the primary difference between the "A" & "non-A" versions of this device? Understood that the non-A is considered NRND today, but my customer…
If designed to supply 5.0A continuous but there are situations where the load can go down to the 10mA range what if anything needs to be considered to remain stable during the load transient for this device?
Kind Regards,
Marc