Part Number: TPS546A24A Hello TI Team,
We have done the schematic design of TPS546A24A buck- regulator with help Design Excel sheet calculator. Kindly review the Schematics, Bode Plot and thermal point view and share your valuable feedback.
Requirements…
Part Number: TPS546A24A Hello TI Team,
I have a query related to EN pin of the TPS546A24A . I wan to enable the regulator through Hardware (EN Pin) with Voltage divider by using the v alues (R1233-10K and R1022- 6.04K). Voltage_En= 1.88V
The Absolute…
Kapil,
I have looked at the 0.8V design, and used the SIMPLIS model to determine stability for 12V and 5V inputs. You can run both designs at 1MHz without hitting the min on time at full load with the nominal 35ns min on time, but at light load you will…
Part Number: TPS546A24A Other Parts Discussed in Thread: TPS546D24A , , TPS546B24A Hi,
What is the Vout (read and write) resolution of the TPS546A24A and TPS546D24A?
Same question for Iout read resolution.
Thanks!
Part Number: TPS546A24A Other Parts Discussed in Thread: TPS546B24A , TPS546D24A Hello E2E,
Is it possible to get the TPS546A/B/D24A device family to sink current? What would be needed to achieve this if it all possible?
Thanks!
Regards,
Russell
teritama
My deepest apologies for the delay in the response. Due to a system error with our E2E forum, we did not see your post until now.
Yes, the TPS546A24A has an internal pull-up current source on the Enable pin called "Ihys", but this current is…
Part Number: TPS546A24A Hello E2E community,
I have done two power supply designs using TPS546A24A with pin strapping only. The PCB have been built and assembled and I'm experiencing some trouble on start-up due to instability.
-Input 10V, freq 550kHz…
Part Number: TPS546A24A Dear team,
Customer would like to set Vboot as 0.8V(floating VSEL pin) and change output voltage by Vout_command by PMBUS after system power on.
They want to double check Vout_command value will not be import in EEPROM and Vboot…
Part Number: TPS546A24A
I have a lot of bulk cap on this rail and the operation is set to "ON". This issue happens when we use the PMBUS operation command to turn on the VR. We don't use the EN pin, or in other words the ON/OFF register is set to 0x1B…
