Part Number: TPS56637 Other Parts Discussed in Thread: , TPS56339 Dear sir:
We expect to use TI's tps56637 for voltage conversion. The required voltage and current are as follows. Is the selection of inductance and capacitance appropriate? Please help…
Part Number: TPS56637 Hi team,
I help my customer to post.
Problem Description of TPS56637 Application (1).docx
Inductor_test1.zip
Thank you very much for your help.
Best regards,
Part Number: TPS56637 Hi there,
For validation I need to adjust the feedback voltage divider (R_FBT) in small steps (Vout +- 5…10%) with a mechanical rotary switch resp. different given resistors (matrix) when no load is connected.
Would you recommend…
Part Number: TPS56637 Hello team,
I am considering 24Vin, 5Vout, 3.2A with TPS56637 and I have questions.
TPS56637 datasheet table 4 shows recommended component values. I think the recommended values are for stability purpose to keep LC double pole location…
Part Number: TPS56637 Hi, in the datasheet TPS56637,
there is recommended component values for Cff and R.
But 1.8V, 1.2V, 1.05V table has blank value for Cff and R as below.
At the low voltage, no Cff and R is recommended?
Part Number: TPS56637 Hello,
I was reviewing table 4 for the recommendations of COUT. In our application, our loads have a much larger COUT effective range than 100uF and I was looking to analyze the implications of this on the TPS56637. I did not find…
Part Number: TPS56637 Hi, I am going to use TPS56637 for my system.
I have two questions using TPS56637.
--------------------
Question 1.
To enable TPS56637, in the datasheet "Driving EN high or leaving this pin floating enables the converter."…
Part Number: TPS56637 Hi,
I have ordered several TPS56637 devices from a distrubutor for an established product and i have recieved two reels - one with an X on the component and one without.
The fail rate on the component featuring the X on is around…
Part Number: TPS56637 Hi team,
My customer would like to calculate the accurate duty cycle. Therefore, could you tell me the switching frequency accuracy? It's ok to estimate roughly like +/-10%. Also, could you tell me the Rdson accuracy for High side…