Part Number: TPS57060-Q1 Other Parts Discussed in Thread: TPS54060 Tool/software: Hello, I started using Pspice for TI to simulate the TPS57060 but I have a problem. INFO(ORPSIM-15422): Making new index file TPS57060-Q1_TRANS.ind for library file TPS57060…
Part Number: TPS57060-Q1 Hi Expert,
When I was testing the characteristics of TPS57060QDGQRQ1 under low voltage state, I found that when the input was 7V and the output was 5.5V with a load of 2mA, the output voltage was a sawtooth wave, as shown in the…
Part Number: TPS57060-Q1 Hello,
I'm a newbie to PSPICE for TI and I'm simulating a circuit with the TPS57060-Q1 chip. I keep getting the following error:
"WARINING(ORCAP-2445): Instance U1: SCHEMATIC, PAGE1 (2.50,1.40), not found in the configured…
Part Number: TPS57060-Q1 Hi,
I'm modeling this IC in SIMPLIS and LTspice and I need the value ( or expression) for the internal slope compensation (Se). The datasheet presents a model that ignores it, but I would love to know what it's so I can develop…
Part Number: TPS57060-Q1 Hi,
I have experienced a failure with the TPS57060, where the device blew catastrophically when the input supply was momentarily interrupted (seconds).
The circuit has been reproduced a few times prior to this occurrence without…
Part Number: TPS57060-Q1
hi Sir/Miss,
May I know if there is any TI tools that can help to calculate the Power Dissipation for this Buck IC TPS57060QDGQRQ1 ?
Like I input output and input voltage, current consumption, then get the power dissipation.
…
Part Number: TPS57060-Q1 Hi team,
My customer is analyzing fault condition and impact to the system.
Is there any negative effect assumed in terms of EMC, due to PAD open fault?
Best reagrds,
Part Number: TPS57060-Q1 Hello Team,
we need more detailed description about the internal switching frequency tolerance of our part:
In our datasheet there is a range of 450 to 720kHz for Vin=12V and RT=200kOhm. Is this including a resistor tolerance?…
Part Number: TPS57060-Q1 Hi Champs,
My customer would like to apply TPS57060-Q1 for Primary DCDC.
There are two input rails, Battery and IG, both rails have range from 10V to 32V as operating range, and 50V max.
IG rail is used to enable TPS57060-Q1,…
Part Number: TPS57060-Q1 Hi Team,
My customer is trying to use TPS57060 DCDC converter with configure of 2MHz condition.
System requirement :
- Vin range ( 10V to 32V)
- Vout = 9V
- Fsw = 1.9MHz to 2MHz
Q.1) Inside the datasheet, only Ton-min typical…