Part Number: TPS60500 Hi team.
Do we have device to meet the customer need?
最小供电电压[VDD(Min.)]
no request
最大供电电压[VDD(Max.)]
≥36V
最小输出电压[Vout(Min.)]
no request
最大输出电压[Vout(Max.)]
18V
最大输出电流[Iout(Max.)]
Maximum…
Part Number: TPS60500 Hello e2e,
we have a customer want to know the TPS60500 die dimension, they may need die for assembly on chip, thanks in advance.
LEON
Part Number: TPS60500 There's an error on page 19 in figure 31 - see the red line in the following image:
Without the connection to FB this can not work.
Part Number: TPS60500 Hello,
My customer is using the TPS60500 to power an MPU core; 5Vin to 1Vo. They are seeing a rise time of 50uS with no load; datasheet shows a typical of 80uS.
The flying caps are 1uF and Co=10uF.
1. Does the rise time vary…
Part Number: TPS60500 Other Parts Discussed in Thread: CC2560B , TPS82740A , TPS62743 , TPS62740 How do I dimension the the feed forward (ff) capacitance for the TPS60500?
There are two examples given with completely different values for the feed forward…
Part Number: TPS60500 The TPS6050x datasheet, page 5, calls out the following specifications for the active low enable pin:
EN' input low voltage = 0.3 * VIN max
EN' input high voltage = 0.7 * VIN max
Is the correct interpretation of these specifications…
Other Parts Discussed in Thread: TPS60500 Hi
I'm having some problem with the TPS60500 on my final design for a project I'm doing. I have a supply voltage of roughly 4.9V which
I want to convert to approx. 3.3V and I've set the voltage divider correctly…
Hello Balasubramanian,
The units should work fine with your setup above.
Just to make sure that you are using TPS60500, could you please check the marking of the units you are using?
Best regards, Brigitte
Other Parts Discussed in Thread: TPS60500 Hi!
I downloaded the .olb file for Orcad for the TPS60500 and I can place the part and everything in my schematic. But I want to be able to simulate
my design as well and for that it seems I need the .lib…
Thank you for considering the LM2665. I cannot think of a way to achieve Vin/3 with this device. Could you select a charge pump with programmable output like TPS60500 instead?
