Part Number: TPS61020 Other Parts Discussed in Thread: TPS61299 We are using the TPS61020 to power a GSM modem in a product. The supply is powered by a 3,9V system and the system also incoorporates a backup li-ion battery in case external power is not…
Part Number: TPS61020 Tool/software: Hi,
Is there a PSpice Model for the TPS610250 96% Efficient Synchronous Boost Converter? I do not see it on the website.
Best regards,
Matthew
Part Number: TPS61020 Tool/software: Hi,
I haven't been able to locate a CB certificate for the TPS61020.
Could someone send a link or point me in the right direction to find it?
Thanks
Part Number: TPS61020 Other Parts Discussed in Thread: TPS61024 Hi,
I'm using this TPS61020.
My requirement is
Vin=6V (4 x alkaline battery)
Vout=3V @ 1000mA
but this is boost converter IC.
it can work as buck boost in this specific ic?
…
Part Number: TPS61020 Tool/software: Hi support team,
A customer reported that the audio signal of their finished product contained tone noise around 40kHz. After investigating, we found that the power output from the "TPS61020" contained noise components…
Part Number: TPS61020 Tool/software: Hi support team, I am using the TPS61020 under the following conditions.
VIN = 2.7 ～ 5.5V VOUT = 5.2V PS = High (power save mode disabled)
There are no particular problems during normal operation, but for about…
Part Number: TPS61020 Hi support team, I have a question about inductor selection.
If I calculate the inductor using data sheet calculations, the input voltage and load will fluctuate, so the calculation will have a wide range of 10μH to over 100μH…
Other Parts Discussed in Thread: TPS61020 Hi,
I am using TPS61020 with 3V battery VBAT voltage. Enable pin is handled thorough external MOSFET as shown below. At start up , when I enable MOSFET V90 ( BAT_EN = 1) , I see glitch on EN pin, which is…
