Part Number: TPS62866 Hi,
I found the TPS62866 would limit the output current (less than 6A) in different output voltage. I want to know if the TPS62866 has the mechanism that limiting the output current (less than 6A) in different output voltage. Tha…
Part Number: TPS62866 Hi,
I found the TPS62866 has two Vout registers which configuration are same. So, I want to know why the TPS62866 needs two Vout registers. Please kindly share information.Thanks!
Best regards,
Ryker
Part Number: TPS62866 Hi,
I have TPS628660DYCGR with switching frequency of 1.1MHz instead of 2.4MHz in the TPS628660AYCGR/ TPS628660BYCGR
If I use the "D" version do I have to use some other inductor ? what is the recommendation for the D version…
Part Number: TPS62866 Hi,
I am using the part switching regulator TPS62866. The Vset resistor values and the corresponding I2C addresses are specified in the table for setting the output voltage.
If a resistor value outside those mentioned in the table…
Part Number: TPS62866 I am working on a design incorporating the TPS62866, however the design is too dense to allow for a resistor in series with the VOS pin.
In this situation, I'd do my testing & tuning on the EVM, however the TPS62866EVM-051…
Part Number: TPS62866 Hello, My customer is sharing TPS62866 I2C interface with other I2C slave devices. When VIN is on and EN is low, TPS62866 SDA and SLC pins are floating so that they do not disturb I2C communication between host and other slave I2C…
Part Number: TPS62866 Other Parts Discussed in Thread: TPS62867 Hi team,
My customer that wants to design in TPS628660BYCGR and he have a quick question.
If there is no MCU at their system, do they just need to set VSET resistor for setting the output voltage…
Part Number: TPS62866 Hello, My customer has some questions about TPS62866. Q1:
Looking at Figure 8-1 of the datasheet, VIN rises first then EN ramps. But, VIN and EN can be connected and they can ramp simultaneously? Q2: They would like to confirm…
Part Number: TPS62866 My customer want to design TPS62866 A & B version in same schematic.
Can customer pull A2 pin low to GND with R=105kohm to compatible A & B version ?
According to D/S, pull low = "Vout register 1" for A version. but not same…